Search:

Does anyone out there have an outdoor schematic or a wire designation map of the old umbilical cord unit? I moved my business some time ago and can't find my dead sea scrolls :-/
Any help on this...

Hello all,
Been a long time since I've been here. Looking for any schematics you may have for furnace based exhaust set ups. It's been a long time since I had to deal with this but I need to...

Very good, we have been in business since 1947. We are seeing the low ball companies going out of business right and left. Had one in particular that was always thousands less and guess what, the...

Heating and air with ducting at 15k sounds about right. This is a pretty vague post as we know nothing about the job. How many supplies, underfloor or attic, how many returns, EAC, UV, metal or...

We have to put drip legs before and after the reg. Sad thing about that situation he's stuck in, my cousin fell through a scenario like that in Norco Calif., he didn't make it.

He did get out rather quickly. The guy is really good. Typically he uses a larger excavator, it was kind of funny cause he slid a little then the guy taking pictures heard say UH OH :eek2:

Got a bit close, of course it was raining as well. Can't get over that here in the great northwet


http://i9.photobucket.com/albums/a54/ifish4fud/IMG00369.jpg

The only slow down was everyone laughing at the situation. It only took a smack with a hammer and a soldering torch.

http://i9.photobucket.com/albums/a54/ifish4fud/img_0688.jpg

Been below freezing for a while here, other installers placed a bag over the lock and filled it with water

I'm surprised all ya'all are even responding to this thread.

Roscoe p tanner, that's perfectly acceptable in Oregon. you see, the rain runs through it :):couch:

We do a fair amount of geo systems (Climatemaster) ground source and pump and dump. We have'nt gotten into solar yet. Hope all works out for you.

Hey Robo, haven't seen you in a while. How have you been? Were cooking here in Oregon, installing tons of Mini Splits. How's life your way? Michael

The sky is pretty. Great setting for viewing fowl

They're protecting it from thieves;)

Not sure what bottom picture your referring to, here's a close up of the race car.
http://i9.photobucket.com/albums/a54/ifish4fud/img_0431.jpg

two Distinguished Flying Cross's with oak leafs on each, a bronze star, purple heart, commendation medal and army conduct medal. The race car is one I sponsored for my brother in law that was run in...

Couldn't make the trip to Vegas to pick up the award, just got it via TM.


http://i9.photobucket.com/albums/a54/ifish4fud/img_0427.jpg

Our guys did a great job to earn this award from Carrier....

not a chance.

None.

The Duck man should be from Eugene Oregon, not AZ or VA :p:D

We just started a retro today. Running the loop today, excavator found another spring however, we were right behind him and the boys got a little muddy but that's it. Had we waited it would have...

True. What region are you in?

Looks familiar

http://i9.photobucket.com/albums/a54/ifish4fud/IMG_1341.png

After

http://i9.photobucket.com/albums/a54/ifish4fud/IMG_1591.png

Don't quite like that myself.

Kind of hard to tell, we use rubber mats under the whole unit.

Nothing.

The glass, and this a simple example,
http://i9.photobucket.com/albums/a54/ifish4fud/img_0392.jpg
Oh my
http://i9.photobucket.com/albums/a54/ifish4fud/img_0386.jpg
The dome...

I am posting this here because I know most all y'all will look here for funny stuff or whacked out stuff. This is one of the most beautiful churches I've had the pleasure of being in. Keep in mind...

Hmmmm. I see where your going. Must investigate. A little late however, we have several in the works and this would be a good time to check that out. Thanks for the tip. If it proves well we'll...

The Desuperheater lines will be insulated, the homeowner wanted to be sure he had no leaks when we fired it off. The only problem I have with flipping the pump pack is that in the event of a leak...

Homeowner building his own home. Did the main electrical and water heaters also. He didn't do too bad however, the electrical could have been a bit nicer. The coffee can is catching the drip from...

Thank you for the info. It is a cool site. Here is a little better pic. You can just see the 2 1/2" exhaust. Had to send a better pic of the Monte. I sure like driving this car. It's pretty...

B&M has master high performance kits. I would rather go with a 400 however the kid can't afford it. I'm sure after this one gets scattered he will make another change.

It's a 78 pretty much the same.

The old 79 belongs to my 19 year old. He just had it professionally lowered. This thing is a beast, 450+ horsepower, problem; he just scattered the second 3 speed I replaced. We bought a donor...

Had a pump failure on one of our delivery trucks. I rebuilt it at home and the misses just loved having the truck in our driveway :eek:

http://i9.photobucket.com/albums/a54/ifish4fud/img_0361.jpg...

I believe you are correct in saying that that would have happened had they put in anything else. There is no indication of pride on this install.

Don't know who installed it. As you can see they were so proud they forgot to put their company sticker on ti.

I would imagine about 75 feet of tubing connected to a shop vac :rolleyes:

That's not an install, that's a train wreck.:eek:

It is done. Pretty cool story you relayed, don't worry about the length. I like to hear stories like that.;)

Don't think this is really shameful, just funny. Went to a leak-er call and found the air vent leaking, didn't have a replacement on hand. Used a glove and cap to seal it temporarily :rolleyes:
...

This unit is about 3 feet to the meter, I thought code was 4, not sure. As for the homeowner that will buy anything, this person is not one of them. He really didn't know that what we are looking...

PS any of you Carrier installers or for that matter, any installers think this is ok, look for another job. PAALLLEEEAASSEE!! This is getting quite embarrassing.

:o:o:o:o:o:o:o:o:o

Nice 120 mile drive to Portland Oregon to look at a boiler project. Beautiful home in the heart of Portland. Made our look around inside and went outside to look where we could "hide" the PVC flue,...

Doesn't your code cover seismic bracing?

Yes, those are drives holding it to the foam and concrete pad. This is not in a snow zone however, a supposed flood area (his neighbor is not :rolleyes:). It is amazing that our competitor put his...

Agreed, much worse. I think the installers found those green blocks behind the shed when they took their "SMOKE" break.

Our salesman went to do an estimate and the homeowner asked if it would look like this (his neighbors). We happen to be a Carrier dealer also :rolleyes:
...