Search:

Type: Posts; User: youngoldtech

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    13
    Views
    1,481

    So by parralelling the transformers you multiply...

    So by parralelling the transformers you multiply the va rating, if I am understanding you correctly. But as one or two goes how do you know unless relays and contactor coils burnout, and you would...
  2. Replies
    13
    Views
    1,481

    Problem wiring up

    I want to paint the picture that I am encountering. I have ripped out a energy managment system, 30 ton Air Handler and two 15 ton condensors that go to it. They have a large heater in the ductwork...
  3. Replies
    5
    Views
    2,539

    I have installed a few in some small commercial...

    I have installed a few in some small commercial applications with electrical rooms and so on. Sometimes they are a pain in the butt to install but I havnt had any problem with them yet. And they are...
  4. Replies
    7
    Views
    1,574

    I agree with HTG Guy, check the exaust for...

    I agree with HTG Guy, check the exaust for partial blockages. Combustion motor is correct from manufacturer. Check obvios things first, check for gas pressure being to high. If that doesnt work you...
  5. Replies
    7
    Views
    1,019

    I guess I see things from a different standpoint...

    I guess I see things from a different standpoint then some, I live in the south and we dont have the cold conditions that many of you may be ocustome to. So as a question to people in the north, do...
  6. Replies
    7
    Views
    1,019

    The Lennox pulse is a very different type of...

    The Lennox pulse is a very different type of furnace than say the tubular you are use to. It would pulsate very rapidly mixing a combination of fuel and air and then ignite it into a large heat...
  7. Replies
    20
    Views
    1,719

    This may not be the most efficient way but very...

    This may not be the most efficient way but very simple, you could put a delay on make timer for the outdoor condensor and when the t-stat calls for the heat pump again the timer will prevent the...
  8. Replies
    7
    Views
    1,019

    I would like to know whether anyone has seen a...

    I would like to know whether anyone has seen a Lennox Pulse in a gas pack. I have and if I am not mistaken the Pulse was close if not at 90% efficient. So why can they not make a 90% gas pack....
  9. Replies
    8
    Views
    1,124

    I agree without knowing outside temps it will be...

    I agree without knowing outside temps it will be impossible to determine whether the heat pump is operatin correctly.
  10. Replies
    20
    Views
    1,949

    I agree with the Doc a 90% furnace will be much...

    I agree with the Doc a 90% furnace will be much better for noise control. And the variable speed blower will help with the noise, as it starts it wont sound like a blast off, it will start slowly...
  11. Replies
    9
    Views
    1,094

    The Kenmore is just a tag put on ICP equipment...

    The Kenmore is just a tag put on ICP equipment like Heil or Tempstar, the reason they say it is a Carrier is because Carrier bought ICP, but I have not problem with ICP equipment, but when it comes...
  12. Thread: fan delay

    by youngoldtech
    Replies
    5
    Views
    1,075

    It depends on the equipment and the age, they are...

    It depends on the equipment and the age, they are all different. But on most newer equipment, and fairly aged equipment there will be a delay. Older gas funaces and some newer ones will not have a...
  13. Replies
    16
    Views
    1,774

    My personal opinion, is to get the D-tech leak...

    My personal opinion, is to get the D-tech leak detector. You will spend a little more, but you will be using alot in the service industry.
  14. I would agree that the Trane would be the better...

    I would agree that the Trane would be the better option. I do like Carrier but the Trane would probably last longer, and look better with age, the Carrier's tend to rust pretty bad.
  15. Thread: seer

    by youngoldtech
    Replies
    8
    Views
    926

    That is rediculous. That is never going to work:...

    That is rediculous. That is never going to work:
    1. You have to have a TXV
    2. The indoor coil has to be larger.
    3. The outdoor coil must be larger.
    All kind of things fall into place to raise the...
  16. Replies
    5
    Views
    921

    Look to see if there is some data on the unit, a...

    Look to see if there is some data on the unit, a piece of paper that tells you all the information on the unit, if you have it. Then you can match up the pressures to that and be pretty dead accurate.
  17. Replies
    4
    Views
    1,010

    Does the pilot go out after an offcycle, and it...

    Does the pilot go out after an offcycle, and it will ignite when you do it yourself and several times after, reason being that I have ran into some cases, where a small crack or bad seal has...
  18. Replies
    5
    Views
    827

    Alot of people dont set the variable speed...

    Alot of people dont set the variable speed motors, alot of the manufactures set the motor at max, you have to check the staic pressure and set the motor to the right speed. There should be some dip...
  19. Replies
    36
    Views
    14,454

    Heil is a ok, they have their set of problems I...

    Heil is a ok, they have their set of problems I would recomend to put a 10 year parts and labor warranty on it, we find different problems, but if installed right you shouldnt have to many but I...
  20. Replies
    9
    Views
    1,044

    I ment to attatch this to another message, but...

    I ment to attatch this to another message, but does anyone else do this besides me?
  21. Replies
    9
    Views
    1,044

    I carry a starter box, that I made it hooks up to...

    I carry a starter box, that I made it hooks up to the compressor and I can try to start it in differant ways, start assist, no start assist, and sometimes forcing the compressor into reverse frees it...
  22. Replies
    8
    Views
    1,136

    Yah I think that the Triathlon was the most...

    Yah I think that the Triathlon was the most innovative system built, it will be brought out again Im sure. But I loved it, the program for replacing them ended in Dec. of 04. It was definatly one of...
  23. Replies
    8
    Views
    1,136

    Do any of you have it like in a Adobe reader...

    Do any of you have it like in a Adobe reader format?
  24. Replies
    6
    Views
    1,133

    Need some info

    How many wires to do have. How many connected to the capacitor and what wire are hooked up hot.
  25. Replies
    8
    Views
    1,136

    I dont know if anyone has a service manual to the...

    I dont know if anyone has a service manual to the York Triathlon, I know this one is a little more difficult to get and the Amana HTM. These are some hard ones to find, and probably some of the more...
Results 1 to 25 of 36
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event