Search:

Type: Posts; User: onemorearrow

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    3,153

    screws

    I used to put 3 screws in each joint. One time I looked up a water heater vent I had just screwed together. The screws didn't penetrate the liner, they just pushed it in. This left a big gap where...
  2. Replies
    5
    Views
    1,362

    hood

    I thought of using a 6" start collar and tee over the outlet, or elling it up about 3' and installing b-vent cap. Kinda hate messing with a factory set-up.
    I had the same problem on another of...
  3. Replies
    5
    Views
    1,362

    rollout

    hvac-tech-lane, Have you ever had a problem with those old Carriers tripping the roll-out switch? I maintain one that trips when a strong north wind blows straight in the vent. Sure would like to get...
  4. Replies
    14
    Views
    1,338

    PEPPERMINT

    I've used peppermint scent to find the general area of the leak. Use the strong stuff from the drug store. It's about $9 per oz. Don't get it anywhere but in the pipe, or you will smell it every...
  5. Replies
    28
    Views
    2,721

    I've heard thats a real nice area, but I've never...

    I've heard thats a real nice area, but I've never been down there.
  6. Replies
    28
    Views
    2,721

    Good advice bwal2

    Good advice bwal2
  7. Replies
    28
    Views
    2,721

    Blowout

    If you reverse R and S, don't stand near the terminal block when you turn the power on. I found out the hard way that it takes about 3 sec. for the block to glow red hot, then blow refer and oil in...
Results 1 to 7 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event