Type: Posts; User: CeeDee
Search: Search took 0.01 seconds.
You're absolutely correct: I got the labels correct on the HA controller, but not on the wall switch(es). I'm planning the Leviton 5634-W as the double wall switch.
Again, thanks for all the...
I was initially puzzled about the switches also, but the cabin kit installation manual shows cold climate (i.e. pilot) is on the brown wires and the on/off splices into the green. I found the...
I think the attached wiring schematic (based on a cabin kit and a temperature sensor from the GFK-160A (HnG's fan kit)) will work. Any comments?
I've contacted a vendor about the cabin kit -- I presume it isn't the same thing as the WSK100. They were surprised that it isn't listed on the Heat'n'Glo website.
This is really helping a lot.
This is very helpful. Thank you.
I had a similar question about how to connect garage lifters to home automation. The general technique seems to be to open the switch and wire a relay in...
Is there any reason why I cannot relocate the battery pack (via 18/2 wire) downstairs to another room? Then heat isn't a problem, and changing batteries is simple(r). Also, am I correct that the...
I'm planning to install a WSK100 to the HnG Cosmo SLR.
I am looking at the WSK100-HNG install manual; it says nothing about leaving batteries in without sucking them dry, and automatically...
Results 1 to 7 of 7