Search:

Seeking Professional Refrigeration Technicians for Chapel Hill, North Carolina Area

Come join our family at Boer Brothers Heating and Cooling. You can never have too many brothers. We are inviting...

Thanks,I might take you up on that.

I am always impressed with your videos, nice installs too. I think that we will start doing this and posting on our website.
Bryan

Thanks for the reply.
There are several different kinds in the cases and three of them recommend temps the 65-68 degree range. these cases are for short term storage
BTW the store does have high...

Thanks for the replies.
I think that what has happened is that there were 4) 45 min. off cycle defrosts on the candy circuit that were programmed in when we replaces the controller for the rack. I...

Hey guys,
I have a few Barker cases that are set to 67 degrees 3 diff and 50% humidity (recommended settings) that are blooming the chocolate (condensing water on the tops of the $7.00 per piece...

If it is that slow of a leak, try some loop conditioner or a non-pressurized flow center.
Bryan

The original well was for potable water for the house and it just did not hit enough water so we are trying to make lemonade out of this lemon.

the one gpm number is for the unusable 650ft water well that we would change to a closed loop 8-9 gpm well. (one loop, pressurized and grouted top to bottom)

I have a house that I am getting ready to install a 038 ttv climatemaster at, the house has a 2.4 ton cooling load and I was planning on using two 300ft vertical wells with one inch pipe. The water...

So I had made up my mind that ventilating dehumidifiers are the way to go for tight houses in my area that require a fresh air vent, but I now have a builder that wants to use ERV's. what do you guys...

does anyone know if there are any hydro/dx fan coil match ups that achieve 16 seer?

Yes I was needing a letter from heatcraft for a city inspector. I got one from heatcraft for 18''. They gave it to me because I was elevating the units on racks and there would be airflow from below....

Any one ever get a letter from heatcraft saying that it would be OK to face the coil on a condenser 18'' from the wall instead of the width of the unit 38'' from the wall. I just cant fit it that far...

Aldridge seems like a pretty good company. Never knew anyone that worked there but they seem to do good work.

That's just not necessary, I've put in all of those including trane and there all fine. You have been tranewashed!

Bingo, allot of micro brews. How well does the Mani self cleaning thing do? any treatments for yeast?

I have got a Manitowoc that has a pre filter and two charcoal filters that is just plane slimy. Are there any companies that will test the water and design a filter-anti slime system for you? I have...

It sure is a beautiful weekend. Keep up the positive attitude. It is obvious to me that your a survivor!
B:)

nice paperwork holder, great job all around!

Hey bud, welcome to the site. I'm one of the "Brothers" that calls you for advice from time to time;) It will be good to have another expert opinion on here.

The Heil 14 seer 2 1/2 ton heat pump with variable speed blower I just sold is a 16seer match. It seems like the three ton units (Heil, Trane) seem to match up better than the 2, 4, and 5 ton.

You better say you were an installer.

Is ACR out of North Carolina going to sell the dsra's. They are a great supplier to work with. (at least from a costumers standpoint.)
B

Go Carolina! Duke Sucks!