Search:

Type: Posts; User: Moose87

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    3,720

    i would have to agree with geo man . Ive had 12...

    i would have to agree with geo man . Ive had 12 carrier wshp that were giving the same symptums and turns out to be water flow issue.
  2. Thread: HG2

    by Moose87
    Replies
    10
    Views
    455

    haha alot of over thinking and a crushed supply...

    haha alot of over thinking and a crushed supply duct
  3. Thread: HG2

    by Moose87
    Replies
    10
    Views
    455

    ive figure everything though thanks

    ive figure everything though thanks
  4. Thread: HG2

    by Moose87
    Replies
    10
    Views
    455

    36000 btu not 3600 my bad

    36000 btu not 3600 my bad
  5. Thread: HG2

    by Moose87
    Replies
    10
    Views
    455

    CFM=3600/1.08*22.8 CFM=1461

    CFM=3600/1.08*22.8
    CFM=1461
  6. Thread: HG2

    by Moose87
    Replies
    10
    Views
    455

    Im getting adequate airflow at the evaportor and...

    Im getting adequate airflow at the evaportor and at the condenser. My subcooling is close to my target subcooling. I just cant figure out what im doing wrong to get my superheat.

    LL pressure:...
  7. Thread: HG2

    by Moose87
    Replies
    10
    Views
    455

    HG2

    When i go to calculate superheat on every unit with the HG2 , once i get result it alway says my temperature is to cold to determine proper charge. And says try raising indoor temperature. Can i...
  8. Replies
    6
    Views
    2,951

    charge seems low , also what was the water temp...

    charge seems low , also what was the water temp coming into your heat exchanger. Pull strainer to make sure you get a good flow through the heat exchanger.
  9. Replies
    1
    Views
    350

    T-900 Master Thermostat

    Im having an issue with my t900 thermostat . I have my sensitivity set to 80 and my temperature to 60. When i came in this morning my steam valve wasnt engaging . when i tapped the control it kick...
  10. Thread: TXV wrench

    by Moose87
    Replies
    21
    Views
    3,272

    sorry really late on this but i use my pump...

    sorry really late on this but i use my pump wrenches on txv powerheads . They fit just right and they are made by wright tools . For a powerhead 43 i use 1" Service Wrenchw/30deg angle. That wrench...
  11. Replies
    12
    Views
    7,046

    yea sounds like some type of restriction in the...

    yea sounds like some type of restriction in the heat exchanger or strainer. Also check the powerhead on the txv and make sure unit isnt kicking out from a freezestat
Results 1 to 11 of 11
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event