Type: Posts; User: orcking
Search took 0.00 seconds.
Thanks its 2800 sqf house
the humidifier is General 1099
The damper is open (its automatic controlled by the smart thermostat)
I can see the hot air flowing and water dripping through the...
I have a whole house humidifier and Lennox furnace
I can't get my humidity above 15% based on my smart thermostat
I can hear the water dripping from the humidifier.
Its connected to the cold air...
One more Question for the experts..
I have a finished basement with multiple supply and return vents that have dampers..
Should I shut off everything in the basement including the return in the...
My system that I bought:
Lennox PureAir has the merv16 in it. So I dont think I can do anything about it from that you mentioned except change the air filter more...
I live in Michigan..
yesterday was 91degrees and humid
could not get it below 78 at day then dropped to 76 at night when the temp outside dropped below 85
I have Lennox XC17 4tons I...
Thanks for the reply
No load calc was done..
I will replace the filter and see.. Also it was the first hot day of the season and the AC was off, could that be a reason for the AC to take a while...
Yes its livable space.
I shut all the vents and return in the basement.
house built 1992
I have no problem heating the house and keeping it comfy...
could a dirty filter do that, should I...
Update I am still at 79 and its set to 76. I checked the vents and cold air is blowing from there and the temp is about 50 Degrees on the register, any ideas?
Is my AC undersized, ?
I had a new furnace and AC installed last year
house : COLONIAL + finished basement (2800SQF without basement)
the AC is 4 tons. SEER 17
This year I just turned on the AC today and noticed...
I forgot to mention that my main concern is heating my 1400 SQF finished basement.
I am debating between two models
and regency L540E
the regency is a bit more $..
Any input would be appreciated...
Thanks for both inputs..
some nficertified contractors said they put fiberglass around the damper and some say if you seal the cap vent properly then no need for insulation.
Its really hard to...
What kind of insulation do you use...
do you touch the vent with the insulation
I have an existing masonry chimney with gas fire logs that I want to replace with an insert.
- Should there be insulation around the vents from the inside of the chimney to prevent draft , and...
Thanks for the quick reply...
So I should leave it alone on circulate?
The reason I want more ventilation is I am getting some condensation and some frost on my basement windows..
I have shut...
I have this Lennox modulating furnace and the icomfort thermostat.
I usually have my fan at circulate, however when I have it like that the fan doesn't kick in in full speed, the problem with that...
So the questions, is this is normal with bypass not going over 38% with VS fans and modulating furnace?
I have a new Lennox modulating furnace with VS fan
I noticed that my humidifier is not able to keep the humidity above 40
it stays around 35% and I can hear it running when the fan is on.
Does it matter because it runs on 35% burn rate most if the time anyway?
No I didn't
how about average for that size house
I also have 4ton 17seer. Ac
I have replaced my 130k BTU 80% old furnace with a SLP98V 110K BTY 97%
I live in SE Michigan and my house is around 2900Sq + 1400Sq basement
is my furnace over sized, and if it is does it matter...
I have now 12*6 combustion register at bottom of door, I will add another one at the top.
I also will add a return vent in the main space as you suggested.
As for the gap between the...