Search:

For broken bolts that are not too rusted in I like to use a left twist drill bit to drill them out. Many times just the drilling force will be enough to back to broken portion out. Otherwise heat...

I don't have one, and don't know if they are made in China but this looks like the same model that you have.

Markwell
...

I've used them when putting stainless behind kitchen hoods and needing to cutout for gas lines. They worked great for that, but haven't used them for much else.

A guy I worked with used the bits from Harbor Freight. I said try my Lenox and he almost pushed the drill thru the duct. The first lenox that I had lasted 8 years until someone else thought they...

For the 4 1/2" and 6" grinders I've used Metabo's for the last 8 years, Never a problem with them. I really like the variable speed 6" ones. Also have used Bosch 4 1/2", but they don't seem to run...

Here is an article talking about acetylene saftey

http://www.thefabricator.com/article/safety/fuel-your-safety-knowledge

Most welding books talk about the 1/7th per hour rule.

I think that...

I was taught to turn off the oxy first. If there is any soot in the tip and/or splatter on the tip, by turning the fuel off first the excess oxygen can cause the fuel inside the tip to ignite. ...

I've brazed 2" with an A-14 tip, it's loud as can be though. I carry an oxy/act setup with a b-tank and an R-40 Oxy for bigger jobs and the MC / R for smaller jobs. Have adapters from b to mc and...

http://www.dewalt.com/us/products/tool_detail.asp?productID=14933

I use one of these for sds bits. It works great putting anchors in above drop ceilings etc. Wish it could do chip only. I got...

Anyone using one of these:

http://www.milwaukeetool.com/ProductDetail.aspx?ProductId=2470-21&CategoryName=SC%3a+M12+Cordless+System

Couple guys at work say this is the best thing since sliced...

I haven't used mine on soft copper. However it works great on hard copper. Mine had a tendency to walk on 1 1/8, but after a couple of cuts you get the idea of how to keep if from doing that. No...

They work good to straighten out dented fittings. You know, the ones that someone dropped the put back on the shelf.

Around here they want you to use purple primer because too many people were using the clear cleaner as a primer.

The clear cleaner will help clean up purple drips on some surfaces. The best thing...

I picked up one of these a few weeks back to try it out. Used it putting in baseboard convectors. Works real good in hard to reach areas. Lots faster than using the imps. It works best on the...

Most of the time our Mitsubishi rep shows up at some point during the startup.

When we installed the TG-2000 software and setup the GB50 controllers he had all the passwords to get us up and...

The CLC 1539 works good for everything that I do.