Search:

Type: Posts; User: JSiemens

Search: Search took 0.00 seconds.

  1. Replies
    13
    Views
    3,144

    Blodgett Follow-Up & Closure

    After years of frustration and endless complaints from cooks, the ovens are now fault free. The secret is in the new spark box....end of story.

    I have never had a centrifugal switch go out, by...
  2. Replies
    13
    Views
    3,144

    Blodgett Closure

    It has been a few weeks since I replaced the Johnson Controls spark boxes with the Fenwal upgrade.............they are now performing flawlessly! The JC controls input around .5 microamp; the...
  3. Replies
    13
    Views
    3,144

    Pulled out all the stops.....installing new...

    Pulled out all the stops.....installing new ignitors and wiring, new flame sensors and wiring, and lastly trashing the Johnson Control spark boxes. Will replace with Fenwal 35-60....I hear that is...
  4. Replies
    13
    Views
    3,144

    Bldogett Oven Failures

    We purchased four new Blodgett DFG-100-XCEL convection ovens back in 2006. From day one we have had problems. Our cooks place food in them, set the timers, and the cooking process starts. They...
  5. Replies
    13
    Views
    5,257

    On The Back Burner........

    The poor dishwasher will have to wait; more important issues going on. I do think that the wash arms and rinse arms are one in the same though. The wash cycle has tons of water flow (due to the...
  6. Replies
    13
    Views
    5,257

    Hobart Dishwasher Rinse Temps

    Actually, rinse temps were not satisfying public health dept. I thought I may have to raise the setting on the control board. Digging into the unit, I found water supply pressures had increased...
  7. Replies
    13
    Views
    5,257

    Hobart Dishwasher Programming

    Does anyone have an instruction to program a Hobart LX30H dishwasher? I have accessed the control panel and found the switches (just not sure what to expect when I start pressing them). My manual...
  8. Replies
    4
    Views
    2,094

    Vulcan Steamer Deliming

    I will add on thing...........I trashed two new Vulcan boilers before switching to soft water feeds...........
  9. Replies
    4
    Views
    1,784

    Case Closed.............Finally!!

    One last blurb.........First, though, I must say that Vulcan has been outstanding to work with throughout my dilema They are difficult to reach in real time but are very good about returning calls;...
  10. Replies
    4
    Views
    1,784

    Gas Regulators and More!

    Thank you very much for the advice. Vulcan has asked I check the pressures at start-up but I am currently awaiting new gaskets before reassembly. This unit needs 2.5" w.c. gas pressure to operate...
  11. Replies
    4
    Views
    1,784

    Vulcan Steamer Driving Me Crazy!!

    One of my Vulcan C24GA gas fired steamers developed a really strange noise in the past two months. It took me a long time just to figure out the noise was actually coming frome the steamer (I...
Results 1 to 11 of 11
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event