Search:

Type: Posts; User: TamarHV

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    28
    Views
    997

    First question: Why do you want to upsize the...

    First question:

    Why do you want to upsize the unit? Simply because the other people did it?
    If that unit was put there and sized correctly then you shouldn't have to upsize period.
    Run a load...
  2. Replies
    2
    Views
    269

    All this thing is, is a glorified flare fitting,...

    All this thing is, is a glorified flare fitting, sure they work well when installed properly.
    I could see a few applications where this would come in handy.
  3. Replies
    19
    Views
    786

    You are right, although in terms of hurting the...

    You are right, although in terms of hurting the atmosphere, the amount of refrigerant we are talking about is minute.. , don't leave refrigerant in your hoses, or anything that holds significant...
  4. The relative humidity is important whether it's...

    The relative humidity is important whether it's occupied or not due to the equipment in the room.

    The batteries are not hydrogen venting.

    I've already figured the load of the batteries into...
  5. Replies
    13
    Views
    346

    No they won't cause a problem if you rip out the...

    No they won't cause a problem if you rip out the other junk thats there and wire it right. It is a start cap/overload/relay all in one, hence the name 3 in 1 if you already have the 3-n-1 (which is...
  6. As I stated before im not sure what exactly what...

    As I stated before im not sure what exactly what its calleD, I checked the specs and ran the load accordingly, it puts out 18,000btus @ 100% which it runs close to 100% most of the time.. That is...
  7. It is a tough situation to be in. But I want to...

    It is a tough situation to be in. But I want to make the best out of the situation. I wont be able to use a split, the fujitsu unit is pretty much set in stone. Not sure about the air-change. I don't...
  8. There is no specific humidity level that needs to...

    There is no specific humidity level that needs to be achieved. But for the sake of argument I would like to see it maintained from anywhere between 30-60% respectively, When I went inside the room...
  9. [B]Installing a 36,000 BTU Fujitsu in a Computer room, have a few questions.[/B]

    Hello gentlemen, and I use that term lightly, (kidding.)

    I was selected for the job of correcting some issues at the computer center at my local college.
    A little information on the room:

    This...
  10. Replies
    11
    Views
    502

    I did. "I took it back and they switched it."

    I did. "I took it back and they switched it."
  11. Replies
    40
    Views
    1,529

    [edit] just realized you had posted that you...

    [edit] just realized you had posted that you found a kink in the lineset, congrats on finding the problem. a kinked suction line will most definitely cause liquid to go back to that compressor, I...
  12. Replies
    17
    Views
    663

    A good tech will measure the static pressure of...

    A good tech will measure the static pressure of the duct and set the blower accordingly, but for all purposes, around 400 cfm is the standard per ton, but you can still be around 350-450 with...
  13. Replies
    11
    Views
    502

    just to update and clarify everyone. they gave me...

    just to update and clarify everyone. they gave me the wrong air-handler, I took it back and they switched it.
    I knew that something wasn't right because i've never installed a system with a larger...
  14. Replies
    11
    Views
    502

    ah FEM4P3600AT cond:N4A336AKB thats what the...

    ah FEM4P3600AT
    cond:N4A336AKB

    thats what the invoice says.. I need to go back and look at what the actual UNIT says.
    because I could have swore it was like FEM4P3000AT, maybe I was wrong. I'm...
  15. Best bet is going to be to try to find a case...

    Best bet is going to be to try to find a case coil that is close to the dimensions of the old one, chances are you wont be able to find the same one.

    Good luck.

    Tamar
  16. Replies
    15
    Views
    659

    I personally take my subcool/superheat right at...

    I personally take my subcool/superheat right at the condenser right by the service valves. I don't like the TYPE-K resistor type temperature clamps/probes that fluke uses so I use a COOPER thermistor...
  17. Replies
    28
    Views
    1,518

    I have to agree with the others, I don't believe...

    I have to agree with the others, I don't believe you have an electrical problem, your issue is with something inside of the system damaging the compressor. Flush the lines and REMOVE the metering...
  18. Thread: No Superheat

    by TamarHV
    Replies
    57
    Views
    3,196

    well is it an upflow or horizontal in the attic?...

    well is it an upflow or horizontal in the attic? if its a horizontal check the ductwork because there may be significant return leaks causing the coil to warm up. which all goes back to airflow.
  19. Replies
    11
    Views
    502

    3 ton condesner with 2.5 ton air handler.

    I am installing a Day & Night (basically the same thing as a bryant/carrier.) matched system on a Good customer of mine's house, I asked the guy @ Johnstone for a slimmer version of the air-handler,...
  20. Replies
    19
    Views
    1,888

    Where I'm working.. and what I got told

    So today I come to work and apparently I had a call back because there was a drain filled with orange vomit looking thick slime. Well I cleared the drain checked operations and it was fine. Well...
  21. Replies
    14
    Views
    1,567

    yeah 10-4. I'm glad I documented it, and even...

    yeah 10-4. I'm glad I documented it, and even TOLD him that same day. That;s also why I prefer the actual customer to be there when i'm there as well :/
  22. Replies
    14
    Views
    1,567

    Drain pan cracked.

    So i'm on call this weekend. And I get a call on my pager and the answering service tells me that he will not give an address, that we created a catastrophe in his house and it was flooding. Well,...
  23. Haha if you're talking about the disconnect it...

    Haha if you're talking about the disconnect it runs through a wooden fence and then back up a brick wall on the other side of the fence.
  24. What a Turd Polishing (Tune up) should look like.

    BEFORE:
    http://i50.tinypic.com/5jsm8i.jpg
    http://i46.tinypic.com/2rfghvo.jpg
    http://i49.tinypic.com/x5qijr.jpg

    AFTER
    http://i46.tinypic.com/2dh915d.jpg
    http://i47.tinypic.com/29vgbnk.jpg
    ...
  25. Replies
    19
    Views
    2,063

    LOL SWIM JUST CALLED HIM AND SAID: SWIM: Hello?...

    LOL SWIM JUST CALLED HIM AND SAID:
    SWIM: Hello?
    GUYS SON: Hello?
    SWIM: This is Jerry's Gun shop, wondering if you need any new guns to take care of future AC REPAIR men, we have the finest...
Results 1 to 25 of 108
Page 1 of 5 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event