Search:

Type: Posts; User: jerrick

Search: Search took 0.01 seconds.

  1. Replies
    18
    Views
    1,535

    let me try

    let me try to help.would the photo of the water pump and evaporator,diagram
  2. Replies
    3
    Views
    667

    check air filter and the vent

    check air filter and the vent
  3. Replies
    4
    Views
    889

    need more information

    need more information
  4. Replies
    35
    Views
    3,865

    i have found out the problem

    try to clean up the nozzle because some rust from the gas pipe block the gas from spaying out. It is similar your car fuel injection
  5. very basic program is ok

    very basic program is ok
  6. Replies
    10
    Views
    892

    i have the same problem

    i am hvac for 5 years.i have a call today some like you.Ls open.the end i found the thermostat bad.but i want found out you problem need the ladder wiring diagam inside the heater.
  7. Replies
    13
    Views
    1,497

    it use prod or sensor to cut down ice?would you...

    it use prod or sensor to cut down ice?would you take a photo about it?
  8. Replies
    18
    Views
    2,635

    chinese repart man

    i am chinese ,call me.1-920-563-7268.state wi.what state are you?it is easy job for me
  9. Replies
    9
    Views
    1,015

    email the compressor # to me.

    email the compressor # to me.
  10. Thread: Tx problems

    by jerrick
    Replies
    7
    Views
    1,099

    I did it one time like you. it is the pressure...

    I did it one time like you. it is the pressure control adjustment problem .You need turn on the system. wait till the evapator freezes then adjust the pressure control untill the compressor turns...
Results 1 to 10 of 10
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event