Search:

Type: Posts; User: Jim The Hut

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    580

    Thanks

    Thank you for the help!

    I really appreciate it!
  2. Replies
    6
    Views
    580

    Cargo Care Engineering HVAC Units

    Greetings All!

    Does anyone know where I can get some information on these units?
    We service one on an old Big Bear Supermarket.

    I did a google search and came up with nothing.

    Looking for...
  3. $$$$$$$

    I think we will go with the heat tape!

    Thanks!

    Jim
  4. Thanks!

    Thanks Jason. That is what I thought we might have to do. I was not sure if anyone had found a way without a heater.

    Thanks Again!
  5. High Effeciency Furnace Condensate Lines Freezing

    We have an installation that due to no inside drains near the furnaces, we piped the drain lines outside. They keep freezing.
    This was before I got here and I would have never done it this way.
    ...
  6. Replies
    22
    Views
    2,441

    Thanks

    Thanks for the input. I really appreciate it!

    Jim
  7. Replies
    2
    Views
    556

    Thanks!

    Thanks for the info!
  8. Replies
    22
    Views
    2,441

    Your Thoughts

    Thanks John,

    Here is the situation. The compressor is running but has shown a higher than normal level of acid. It is a Carrier Chiller. The customer got a quote to remove the oil, dispose of...
  9. Replies
    2
    Views
    556

    Inexpensive Load Calc Software?

    Anyone have a recomendation for an inexpensive load calc software that you do not have to be an engineer to operate?

    Thanks in advance for your input!:cool:
  10. Replies
    22
    Views
    2,441

    Question

    Would you agree though that the better place is on the suction side so that you can catch any acid that might be trapped in the oil throughout the system before it reaches the compressor instead of...
  11. Replies
    22
    Views
    2,441

    Acid Clean Up

    Has anyone ever installed a changable core drier shell on the liquid line of a chiller to clean up acid in the system. The reason I ask is a customer has a quote from one of the Manufactures to do...
  12. Should Be Ok

    I would have a tech ohm out the compressor to make sure the windings are ok. The other suggestion of putting temp power is also a good one.

    It shoud be ready to go like new!:)
Results 1 to 12 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event