Search:

Type: Posts; User: killeentech

Search: Search took 0.01 seconds.

  1. Replies
    7
    Views
    1,951

    unmounted cap

    Go on service call behind a fellow tech that was there a couple times for a condenser breaker tripping. Bad part is the wires were long enough to reach factory cap mount.
  2. Replies
    7
    Views
    2,291

    Thanks for correcting pic . That is the front of...

    Thanks for correcting pic . That is the front of unit
  3. Replies
    28
    Views
    3,338

    I bet closest to end plenum are the coldest . (No...

    I bet closest to end plenum are the coldest . (No mixing chamber)
  4. Replies
    7
    Views
    2,291

    Rheem electric airhandler with cased evp stuffed...

    Rheem electric airhandler with cased evp stuffed in it still in case. I have seen to around town so far
  5. Replies
    28
    Views
    3,338

    No mixing chamber on plenum, if no duct leakage.

    No mixing chamber on plenum, if no duct leakage.
  6. Replies
    7
    Views
    2,291

    rheem with ICP cased evp

    Rheem evp is probly cheaper .. how do i rotate the picture ? Should be left side up
  7. Could it be compressor running in high pressure...

    Could it be compressor running in high pressure bypass . Had one onfirday we install in fall installers had close to 5 lbs of 410a to much. Homeowner said cooled great till it got 90 plus outside .
  8. Could it be in tstat settings " cycles per hour"?

    Could it be in tstat settings " cycles per hour"?
  9. Replies
    1
    Views
    537

    leak detector

    Anyone got one of this? Cps leak-seeker II. Any good or junk
  10. Replies
    1
    Views
    547

    You need a ARH4 head

    You need a ARH4 head
  11. What yall do with the direction leds on condenser...

    What yall do with the direction leds on condenser motors?
  12. Replies
    25
    Views
    2,893

    What is eddy effect?

    What is eddy effect?
  13. Replies
    20
    Views
    2,817

    It was explianed to me to use only oem start...

    It was explianed to me to use only oem start assits . Because 5 2 1 kit have a relay remove the stick on side it gives u a # ???-??? Which is voltage drop out. Which needs to match oem...
  14. Replies
    5
    Views
    1,847

    Because its a electric down flow moblie home...

    Because its a electric down flow moblie home unit. Usually the flex leads to roof and has a power open damper for fresh air. This are terrible for dirty evp coils be cause filter lay right on evp...
  15. Replies
    13
    Views
    3,223

    Some poeple have no pride

    Some poeple have no pride
  16. Replies
    12
    Views
    2,035

    Thanks frosty beer the picture is right now....

    Thanks frosty beer the picture is right now. Someone removed rheem mcoil and section and place goodman cased coil in it place. I was glad it was a sales call not a no cool call
  17. Replies
    12
    Views
    2,035

    Upflow

    Upflow
  18. Thread: crackheads

    by killeentech
    Replies
    4
    Views
    1,824

    crackheads

    Bids from last month copper must have been up . Can you tell plumbers missed closet with chase
  19. Thread: my luck

    by killeentech
    Replies
    9
    Views
    904

    More pic

    More pic
  20. Thread: my luck

    by killeentech
    Replies
    9
    Views
    904

    my luck

    For who wears rings at work.i aas soldering a tap ona window unit . Solder driped on my wedding ring and stuck i couldn't get it off till it cooled. It sucked to topto all off this happen on 4 30 12...
  21. Replies
    12
    Views
    2,035

    who thinks this up?

    Seen this on a sales call.the evp was a 2011. At first i had to pinch myself maybe i wasin a wall of shame twilight zone . Then i fist pumped in my head . Ihave to show my find off :grin2:
  22. Thread: RTU

    by killeentech
    Replies
    27
    Views
    3,247

    isnt this a forum for questions. Thanks...

    isnt this a forum for questions.
    Thanks jpaulsmith . I know very simple question just was never explained to me
  23. Thread: RTU

    by killeentech
    Replies
    27
    Views
    3,247

    RTU

    How long does a evp blower belt normaly last and how often should very be replaced?how tight shouldthe belt be ? Also how to check pulley alignment?
  24. Replies
    5
    Views
    870

    Smart thinkin .. i like

    Smart thinkin .. i like
  25. Replies
    23
    Views
    8,327

    Ihad a low pressure switch on a carrier hp that...

    Ihad a low pressure switch on a carrier hp that had a loose connection inside the switch . Caused contactor to chatter and fryed contacts.
  26. Replies
    23
    Views
    2,863

    If airhandler has evp coil on bottom i stick cell...

    If airhandler has evp coil on bottom i stick cell phone in filter slot and snap a few pictures and review. Saves alot of time and guess work. Coil above blower to easy to remove evp cover slideevp...
  27. Replies
    5
    Views
    1,035

    I second this

    I second this
  28. Replies
    16
    Views
    1,944

    I am pretty sure Time delay will work with a...

    I am pretty sure Time delay will work with a common or with batterys.
  29. Replies
    7
    Views
    837

    Open face coil ? Like in a down flow trailer...

    Open face coil ? Like in a down flow trailer house unit?
  30. Replies
    5
    Views
    738

    RGF ON CARRIER INFINITY

    How would one add a RGF to a infinity to run with fan not all time?
  31. Replies
    16
    Views
    2,915

    here today gone tomorrow

    I serviced 6 goodman 5 ton r22 heatpumps the next day they were all gone. From a church. Its a shame.no one is safe.
Results 1 to 31 of 37

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Quality Home Comfort Awards