Search:

If you have a programming manual for the Microset I it would great if you could send it to me. Thanks

Does anyone have the manual for the Microset I? Any help is greatly appreciated.

If anyone has programming information on the Microset I can they please send it to me.

Yes they do have that stereo jack style plug. Do you know where I could get a microset with a cable and instructions on how to use it. They do have 3 wires to the sensors. Thanks

No displays simple sensors with a slide and port. I thought I could set min max setback ect. with a plug in device of some kind?

I just got an account with 50 of these vav controllers. I assume I could plug into sensor with a laptop or palm for setup ect. I never worked with these before does anyone have any helpful info. Any...

Keep an eye on the t stat and unit when its cycling off. Determine if the unit is cycling off because the t stat is satisfying or the unit is shutting before set point is reached.

Never mind found it. Thanks

The thermocouple is bad but it is fixed to the pilot/ignitor assembly does anyone know where I can get a replacement?

Thanks great site

I looked at a gas vent less fireplace for a friend and the pilot is not staying lit. I tested the thermopile at 250mv max. I never work on these and I am wondering what the rating should be? Do...

You should have replaced the header assembly and to cut ref. lines with a SAW is not a good idea.....

Just cut each inlet to evap coil with snips as far back to header as possible then unbraze one at a time. Hope this helps that's the way i do it

looks like 2.5 ton

I hate to see all those wire ties on the armor flex. Why not sleeve on the armor flex before brazing your last connection? Looks better and lasts longer.......

I have not been there yet but it is supposed to be older stuff.

Thanks any help is appreciated.

I am servicing several buildings with teletrol controls. Does anyone know i where i can get any information and software to access this system? Any help is appreciated.

Anyone know of any good commercial HVAC company's looking for service tech. with 10+ years experience in the central N.J. area.

If these are semi's may want to reverse rotation, sometimes oil pump will be running backwards.

you can also bend the louvers open more . This sometimes helps if sizing isn't too far off. Taped seamers is best for doing this so you don't scratch the finish.

Work looks nice and neat but why the t and open pipe after trap over furnace?

is there an electronic air cleaner ? (ozone at low speed)

70 deg. loop temp in heat mode with 6 deg. differential.

I am working on a new account with several 40 ton (RCRM) water cooled rtus (aprox 25 yrs old) (4-10 ton comps). Several compressors have been replaced, charged in ac mode 10 deg sub cooling and 12-15...