Search:

Type: Posts; User: Razor Jeff

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    2,297

    I thought that the oils were different for 22 and...

    I thought that the oils were different for 22 and 410? I know the coils are the same just different tx, but don't you have to flush oil out of the coil if you were installing a 410 unit?
  2. I don't think the air flow is the problem. If...

    I don't think the air flow is the problem. If the supply air temp is 125-130, that should be around a 55-60 temp rise. Without knowing the certified temp rise on the unit I couldn't say for sure...
  3. I live a long way from Texas so I can't say for...

    I live a long way from Texas so I can't say for sure what the best solution is. Up here, in the winter, the outdoor RH drops because the cold air outside can't hold much moisture. Over ventilation...
  4. Replies
    82
    Views
    13,752

    You seem to have a lot more in depth knowledge of...

    You seem to have a lot more in depth knowledge of the subject than I do, but as far as I have ever been able to figure out, heat transfers from hot to cold. The more the temp. difference the faster...
  5. I have been told that condensate into cast...

    I have been told that condensate into cast plumbing is a bad idea. I have never seen cast plumbing deteriorate to the point of unusable but it only makes sense that it will happen in time. I have...
  6. Typically a 4" filter should last alot longer...

    Typically a 4" filter should last alot longer than 25 days. That being said, if you didn't have your ducting cleaned prior to the install, the higher airflow rate of the new furnace can pull a ton...
  7. Check your filter, on any Infinity furnace (or...

    Check your filter, on any Infinity furnace (or most variable speed furnaces for that matter) the variable speed fan will ramp up its rpm to try to maintain whatever airflow it wants. If your filter...
Results 1 to 7 of 7
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event