Search:

Type: Posts; User: Snapperhead

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    21
    Views
    475

    have you put gauges on this thing yet ??

    have you put gauges on this thing yet ??
  2. Replies
    53
    Views
    909

    I smell a Green tech .... For someone who...

    I smell a Green tech ....

    For someone who owns a business , you evidently haven't seen much wiring

    Without a common , how would you get 24v ? ? Its not needed at the thermostat , but its...
  3. Replies
    10
    Views
    270

    I have found from my experience , you cannot let...

    I have found from my experience , you cannot let the coil run for too long below 20 , or it will freeze , so yea 19 is a good number , but no lower
  4. I would say look , I replaced your compressor as...

    I would say look , I replaced your compressor as requested , but you have other problems , ones that caused the old compressor to quit. This one will quit very soon. Cut a hole to gain access to the...
  5. Replies
    17
    Views
    513

    ive done that in a pinch too , just check amps to...

    ive done that in a pinch too , just check amps to be sure its close to the label .... so im not alone huh , i like to think of it as shop class experimenting lol
  6. Replies
    9
    Views
    361

    did acid test , no acid

    did acid test , no acid
  7. Replies
    9
    Views
    361

    Installed suction core replacable filter , 200...

    Installed suction core replacable filter , 200 friggin dollars , hh filter in that, 164 threaded sporlan in liquid, and bottle of acid away

    Will change filter in mornin and acid test
  8. Replies
    9
    Views
    361

    I was actually thinking of doing exactly that ,...

    I was actually thinking of doing exactly that , but i didnt know if they offered hh cores , but if they do im doing it
  9. Replies
    9
    Views
    361

    cleanin up big acid problem

    Walk in beer cooler , 2 evaps , copeland semi shorted to ground. Test strip turned red immediately. It smells horrible , kinda burns my nose just doing to 2 second test.

    Id like my new compresor...
  10. You might wanna check discharge line temp 330 is...

    You might wanna check discharge line temp 330 is kinda high .... 22 right ....
    May need to remove some refrig

    Od coil nice and clean ? Is air blowing up , or kinda outwards?

    Then again , it...
  11. This is existing system and has been running ? Id...

    This is existing system and has been running ? Id like to hear the pressures you get .... Nobody goes bigger on OD unit , so do post your outcome , along with sh sc if you can
  12. This is why you Always Always Always get 3...

    This is why you Always Always Always get 3 estimates , never trust anyone
  13. No , low side sensor was going out. Tied wires...

    No , low side sensor was going out. Tied wires together and been runnin great. Coil came clean with plain ol water
  14. According to the manual you sent its a dirty...

    According to the manual you sent its a dirty filter, which told me its looking at airflow somehow, so i bypassed sensor on blower wheel , that wasnt it

    So i started thinking the plugged up coil...
  15. Been here since 7am trying to work between rain...

    Been here since 7am trying to work between rain showers. It keeps pouring down on me. All ive been able to get is this.

    Turned unit on at 7, it ran for 40 min before shutting off. I couldnt do...
  16. YSCO72E3RMAOR 00000000000 SER.... 944100321L

    YSCO72E3RMAOR 00000000000

    SER.... 944100321L
  17. Oh , One thing i noticed , air doesnt blow...

    Oh , One thing i noticed , air doesnt blow straight up , more of outwards , but coil looked clean .... blade on correct , going correct direction , cap tested good
  18. It was 96 and muggy , i slapped a belt on , took...

    It was 96 and muggy , i slapped a belt on , took a few amp readings , felt the air commin out top , and left.

    Suction was sweaty ( its probly beer can cold)

    They turn the main breaker on / off...
  19. 6 ton Trane rooftop unit , hard fault ?

    Every few hours its shutting down. Board gives 2 blinks. Data sheet says hard fault lock out. Ok that tells me nothing.

    Only thing i found was blower belt loose and barely turning, replaced that...
  20. Bill how much ? No, i no pay ,too much money, you...

    Bill how much ? No, i no pay ,too much money, you need give discount.

    Oh ok, how about i knock off the extra 50 i added on top , theres your discount lol
  21. Store property is owned by a chinaman, indians...

    Store property is owned by a chinaman, indians own store , its like a 7-11 with bunch of coke coolers , but add a kitchen with stove and fryers. Ac is resi unit 4 ton , good luck to them...
  22. Replies
    7
    Views
    444

    It actually runs really well , pulled down...

    It actually runs really well , pulled down quickly. Best part was , it had the king valve on low side which made it nice.
  23. Replies
    7
    Views
    444

    Long story short , 2 years open , cant find good...

    Long story short , 2 years open , cant find good help, business partner said wanted out , now hes strugglin to keep lights on with hopes it picks up...

    Little Turbo Air , M3 , nice little unit ,...
  24. Replies
    7
    Views
    444

    cheap customer gets cheap parts

    Looked at his prep table with R134 , has a samsung compressor not pumping, and ive seen these junk samsungs do this before, so i told him i can install a nice copeland for couple hundred more.

    Oh...
  25. Man i sure do hope their is a god , because if...

    Man i sure do hope their is a god , because if not , you two are wasting an Enormous amount of your lives talking about nothing ....
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event