Search:

Yes it could be a big deal as long as it is comm3 isolate ie not polarity sensitive already have driver for the comm3 non isolated ie polArity sensitive

The interface is a torroid transformer the protocol is audio just as modem audio that is the data highway

i tried to email you the answer but your email bounced email me at dlhvac@ptd.net

i use an infocon easyio 30p or a spyder micro

the sensor has the output rating right on it i cannot recall offhand but the bypass damper cannot be controlled by the jace you must replace this controller with another the ccp panel previously...

yes but usually the supply house you purchase the driver from is the first contact i use broudy supply in philadelphia, also cochrane supply in mich has the driver

worked well have done a bunch since then 12 or 13

9600 8 none 1

broudy supply in phila has the drivers

yes it is available thru maxline drivers with infocon support for 10 years

Does the install have trane purple wire if not your on your own

Approx 80 or more points per rtu all the diagnostic alarms and you can also reset diagnostic faults

You can see more of the voyager and reliatel points than with tranes software

The zoning and rtu overides are done in the jace

I would use a six if you are putting graphics on it if noy jace 2 should work watch your java heap and busy time on the jace comm four is a reource hog

Sorry but i dont give away stations that ive done but it is doable to integrate all that you stated

Maxline drivers owms the comm4 driver infocon sold the driver division go them but has a contract for 10 years to provide support

worked very well have done 12 to date

you have to put the unit in tracer control and command the input mode

the ashrae show sent you an email

the ashrae show

THE CONTROLLERS WILL BE OUT AT THE SHOW IN DALLAS IM BETA TESTING A PROTOTYPE

Have over 50 installed at different sites all work flawlessly and yes they talk sedona modbus and bacnet all at the same time the new ones due out will have its own html5 graphics engine and it own...

Forgot using lon requires the firmware in chiller to be the latest Trane will have to upgrade recommend using comm4

There are some issues with the commissioning of the lci-c chiller lon cards you have to set the response to the jace at no response to commission because some of the cards do not send this response