Search:

Type: Posts; User: klyons20

Page 1 of 20 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: houston area

    by klyons20
    Replies
    3
    Views
    318

    houston area

    iam visiting from Detroit I need a 20kw heat for a a goodman61-10 unit. and a spw-01.
    I don't think my Michigan license will work. at johnstone

    regards,
    Kelvin
  2. Replies
    19
    Views
    1,699

    sound like draft motor to me

    sound like draft motor to me
  3. Replies
    4
    Views
    1,166

    check voltage coming to furnace if les than 110...

    check voltage coming to furnace if les than 110 volts then switch breaker to other leg. Put breaker on highest voltage leg in breaker box. and are replace wire to spark probe (make sure has a good...
  4. Carrier / Bryant Draft Inducer Motor 318984753, 318984-753

    I have 10 year old furnace flame floats a litte going into heat exchanger. cycles out on flame senor..
    When i remove vent pipe flame flow normal.. Iam thinking new draft motor.
  5. Replies
    40
    Views
    12,309

    There are suggested books that you can read for...

    There are suggested books that you can read for the test... You need to know code to pass.
  6. Replies
    5
    Views
    4,635

    Super-Freeze 22a Refrigerant

    Super-Freeze 22a Refrigerant - R22 Freon Drop-in Replacement - 30 lb Equivalent

    Anyone using the Super-Freeze 22a Refrigerant ?

    What you take on it?

    Any cons?


    regards,
  7. Replies
    6
    Views
    1,154

    Pull fan motors and clean secondary heat coil...

    Pull fan motors and clean secondary heat coil just above the fan! Use a coil cleaner.
    This could be your problem
  8. Replies
    1
    Views
    744

    whirlpool gd5shaxlq02 ice maker

    whirlpool gd5shaxlq02 ice make stop working..

    the arms on the ice maker seem to be normally position.

    There is a wiring harness that connects the ice make black white green brown. How do i...
  9. fan limit switch vs a fan control board

    A fan is controlled by two ways a temperature switch or a fan board
    The fan board will run regardless of the temp.

    fan limit switch
    The temperature switch will open and close the switch based...
  10. I work on a loading dock we use around 150k btu...

    I work on a loading dock we use around 150k btu to 250k btu per door.

    They run 24 hours. There no match agaist and open door.
  11. This is normal behavior is you are using a...

    This is normal behavior is you are using a combination fan limit controll.

    If you want a unit to catch up fast then put a bigger unit in or more units.
  12. Replies
    15
    Views
    981

    u need some one in your area.. Call and get...

    u need some one in your area.. Call and get prices to replace..
  13. Replies
    40
    Views
    12,309

    Heating and Cooling Essentials

    Heating and Cooling Essentials (Hardcover)
    by Jerry Killinger
    Jerry Killinger (Author)
    › Visit Amazon's Jerry Killinger Page
    Find all the books, read about the author, and more.
    See search...
  14. Replies
    40
    Views
    12,309

    Buy book heating and cooling essectians by...

    Buy book heating and cooling essectians by ladoona read heating section
  15. Replies
    16
    Views
    24,264

    use less energy

    [QUOTE=rChris;1511988]Not looking like Rheem makes a VS furney, just a 2 stage that has a ECM motor.

    So if that's the case, could someone esplain what's so great about these motors. Looked at the...
  16. dirty coil

    A dirty filter can not cause a coil to leak. These new puron system are under a lot more preasure than r-22. So if everything is not done perfectly in the installation you will get leak down the...
  17. Replies
    21
    Views
    5,252

    make sure control voltage is constant

    Make sure control voltage is present to determine if contactor is not working.
    I feel like something in the circut is opening up.
  18. Replies
    4
    Views
    609

    Quiet Running Ac Unit

    Who makes the quiet running Ac Condener R-22.
    I had a magazine that show all the unit and the decimal rating.
    Iam replacing a condenser and the costumer insist on a quiet running system.
    I will...
  19. This calls are a pain in the behind. You have to...

    This calls are a pain in the behind. You have to pump down the system put an 160 psi of nitrogen and do a buble test. Close the valves and come back the next day to see what side is leaking the a...
  20. Replies
    16
    Views
    1,385

    mechanical code book

    Normally the BW vent change to B vent once it enters the attic. So you would use the same code that applies to b vent. Slop of the rood decides how tall the vent pipe should be. As long as this is...
  21. Replies
    14
    Views
    1,311

    ok

    set t stat to lowest setting . you only want to keep it above freezing.


    regards,
    Kelvin
  22. hello

    Piece where are you from?
  23. Replies
    2
    Views
    1,104

    Are they any beginners that need a little on the...

    Are they any beginners that need a little on the Job Training? You will provide the free help. I will provide you the experience.

    Regards,
    Kelvin Lyons
  24. Replies
    11
    Views
    1,105

    dont do it

    Dont waste you time .. These units will not fit most applications..

    regards,
    K
  25. Replies
    2
    Views
    638

    Why do the good man sound like a cannon ball when...

    Why do the good man sound like a cannon ball when starting.
    I need a quiet furnace for a job installation in the attic above the bed room. I am on a tight buget.

    Goodman product or comfort air...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event