Search:

Type: Posts; User: airconman

Page 1 of 11 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    514
    Views
    82,621

    Went out to a trailer house, just happened to...

    Went out to a trailer house, just happened to look up and no chimney cap... hmmm... went inside guy was a jerk, walks by and says just light it..... top door is on this trailer house furnace, 20 guys...
  2. Replies
    72
    Views
    4,005

    you can be missing one leg of your 220 and still...

    you can be missing one leg of your 220 and still get 110 on both sides...... or is it 120 and 240?
  3. Replies
    72
    Views
    4,005

    Do I have a pro membership?

    Do I have a pro membership?
  4. Thread: Beginner

    by airconman
    Replies
    10
    Views
    204

    What I've found is, you never quit learning. Or...

    What I've found is, you never quit learning. Or your in trouble.
  5. Replies
    23
    Views
    1,025

    I told this lady, what idiot told you that? She...

    I told this lady, what idiot told you that? She said I'm not gonna tell you. But it's Mr 80 year old man in town that used to think he was a furnace guy.
  6. Replies
    19
    Views
    1,259

    sounds like a crack in secondary..... and when...

    sounds like a crack in secondary..... and when you pull that cover off, you'll probably find little rings off the primary. Take a CO test in the flue pipe, it should be less than 100 ppm. or 400...
  7. Replies
    19
    Views
    1,259

    Put a CO tester in the exhaust vent. Maximum is...

    Put a CO tester in the exhaust vent. Maximum is 100 .......or 400 free air... you could be seeing 1200 and that my friend is a secondary problem. Carrier seems to have these problems big time...
  8. Replies
    9
    Views
    772

    Yep start with the trap.... I did have a heil one...

    Yep start with the trap.... I did have a heil one time have a bad gasket on the inducer motor.....It would run about 4 minutes and the pressure switch would go into convulsions...
  9. Replies
    8
    Views
    328

    Any downflow furnace should have the coil mounted...

    Any downflow furnace should have the coil mounted on the supply side of the furnace. On the Bottom. Mounted on top causes premature rust on the HE.
    Although about every downflow I've seen this...
  10. Replies
    23
    Views
    1,025

    Ok the rest of the story...... I told this lady...

    Ok the rest of the story...... I told this lady that her house had no CO in it, and that crack should be shut down..... I had her buy a CO detector and tried to get her a free furnace from two...
  11. Replies
    23
    Views
    1,025

    This is the problem, some say it's bad, some say...

    This is the problem, some say it's bad, some say it's good. I always figure ANY crack, Anywhere it can spread and let exhaust fumes into the conditioned area, is a shutdown. But seems like 1 in 10...
  12. Replies
    23
    Views
    1,025

    Well it isn't blowing the pilot out yet, so does...

    Well it isn't blowing the pilot out yet, so does the pilot and the end of the burners burning flame on a 1/8 inch crack safe? 1/8 wide and 1 1/2 inch across... burner to burner crack. More of a...
  13. Replies
    23
    Views
    1,025

    crack in HE? OR not crack in HE?

    hey fellers, got a quick question about a Rheem
    80 percent furnace, the famous crack above the
    pilot light. This crack goes from cell to cell across
    It is not blowing the pilot out yet.
    Ok to...
  14. Replies
    35
    Views
    5,555

    have your dealers show you their products in...

    have your dealers show you their products in action. You'll go Trane then.
    It's worth the extra. You cannot bid a Trane with a Goodman, it won't happen Trane is more expensive. Goodman has come...
  15. Replies
    10
    Views
    698

    I've found water in pressure switches for no...

    I've found water in pressure switches for no reason, usually at start of winter. Get that water out or replace it and it should fire.... It's a pressure problem anyway. Whip out the old magnahelic...
  16. Replies
    14
    Views
    2,487

    ya your right buy a trane and relax..... as I...

    ya your right buy a trane and relax.....
    as I duck for cover from the goodman guru's...... INCOMINGGGGGGGGGG!!! I think most the guys here must sell goodman or work for em.... but I like their...
  17. Replies
    46
    Views
    4,221

    I don't wanna argue as much as the goodman guru's...

    I don't wanna argue as much as the goodman guru's but here's an example...
    I put a Trane in for a guy, his neighbor puts in a Goodman in his new house down the road. They are friends.
    Good...
  18. Replies
    8
    Views
    681

    19 years. hmmmm Yea I'd consider changing it. ...

    19 years. hmmmm Yea I'd consider changing it. More efficient these days.
  19. Replies
    11
    Views
    962

    But then down the street there's the old lady...

    But then down the street there's the old lady glad to see ya....... don't forget them.......and I think I need a beer after hearin he had one of my weeks.
  20. Replies
    5
    Views
    1,124

    Thanks Looney.

    Thanks Looney.
  21. Replies
    13
    Views
    5,396

    contactor probly stuck...

    contactor probly stuck...
  22. Replies
    14
    Views
    2,487

    Goodman Guru's like to argue I know that.........

    Goodman Guru's like to argue I know that...... but I'd go with carrier and I sell Goodmans toooooooooo, but I don't sell carrier. That tell ya somethin?
  23. Replies
    46
    Views
    4,221

    I just hate the part,when you put a goodman in...

    I just hate the part,when you put a goodman in where you have to go apoligize to the neighbors for noise of the condensor.
    Oh by the way Goodman quit putting out the lifetime warranty deal on the 14...
  24. Replies
    5
    Views
    1,124

    Anyone know what size this condensor is? Model...

    Anyone know what size this condensor is?
    Model # HS94113P
  25. Replies
    3
    Views
    1,142

    first of all.....after Jan 2006 noone is allowed...

    first of all.....after Jan 2006 noone is allowed to manufacture 12 SEER any more... 13 minimum.
    heat pumps are better choice. cheaper to run than gas down to about 25 30 degrees then gas takes...
Results 1 to 25 of 267
Page 1 of 11 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event