Search:

Type: Posts; User: wptski

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    1
    Views
    290

    Don't know if this would apply to you but read...

    Don't know if this would apply to you but read this thread on a regular scale:...
  2. Replies
    62
    Views
    5,740

    What's the point since you have an iManifold and...

    What's the point since you have an iManifold and /or iConnect? Just like to test things? :grin2:
  3. Replies
    50
    Views
    2,556

    True in some ways but sometimes the third party...

    True in some ways but sometimes the third party does the app support as well. It's all farmed out. An example of this is I have a Smart Electrical Meter on my home from the local provider, DTE. ...
  4. Replies
    50
    Views
    2,556

    Developing software and/or hardware outside the...

    Developing software and/or hardware outside the company is nothing new. The automotive O2 sensor was developed by Bosch and the TPMS system was developed by Schrader. I know of at least one YJ...
  5. Amprobe is owned by Fluke now, try them.

    Amprobe is owned by Fluke now, try them.
  6. Replies
    49
    Views
    4,603

    RED is made from mineral oil but do you really...

    RED is made from mineral oil but do you really think that the small amount used is ever going to cause a problem if used on R410A??
  7. Replies
    49
    Views
    4,603

    JoeyD the guy that designed the BluVac stated if...

    JoeyD the guy that designed the BluVac stated if you use too much NyLog and it gets inside the unit it can't be flushed out in the field. It will have to be returned for service. I "assume" this...
  8. Thread: Supco CO1000

    by wptski
    Replies
    2
    Views
    858

    Like most CO detectors the sensor within doesn't...

    Like most CO detectors the sensor within doesn't last forever. If it's old so is the sensor. Typical sensor life on the Supco CO1000 is three years.
  9. Thread: Meter Leads

    by wptski
    Replies
    12
    Views
    1,452

    I think it's 1/4" tubing and when slide on up the...

    I think it's 1/4" tubing and when slide on up the tapered tip, they have to be pulled off. Slipped through a twist tie attached to a bag buckle works. I keep two in the battery compartment of my...
  10. Thread: Meter Leads

    by wptski
    Replies
    12
    Views
    1,452

    A couple pieces of clear vinyl plastic tubing...

    A couple pieces of clear vinyl plastic tubing trimmed to the proper length on standard probes works just as well as twist probes.
  11. It was posted in another thread that the app...

    It was posted in another thread that the app allows assigning of low and high pressure probes.
  12. Replies
    26
    Views
    2,006

    I used a piece of 1/4" wooden dowel to poke the...

    I used a piece of 1/4" wooden dowel to poke the large one in there so as not to damage it.
  13. Replies
    26
    Views
    2,006

    If you take the depressor out you'd have to...

    If you take the depressor out you'd have to remove the valve core as well from anything it's used on.
  14. Replies
    26
    Views
    2,006

    If you mean in the swivel, no diagram needed. I...

    If you mean in the swivel, no diagram needed. I always got old dental pics from my dentist's office as they work great on removing "O" rings. They swell up as they are used and come out hard. ...
  15. Replies
    16
    Views
    882

    My JB Eliminator 3CFM pulls below 20 microns all...

    My JB Eliminator 3CFM pulls below 20 microns all the time.
  16. Look here:...

    Look here: https://play.google.com/store/apps/details?id=com.ritchieengineering.yellowjacket&hl=en
  17. Replies
    26
    Views
    2,006

    I've also ran into the problem with Appion VCRT...

    I've also ran into the problem with Appion VCRT Schrader valve cores using a BluVac and YJ brass adapter. Not sure if it was adjusted too deep or not enough.
  18. Replies
    10
    Views
    934

    Widely used in automotive work and it's called...

    Widely used in automotive work and it's called "back probing". Here's just one kit available from many manufactures: http://www.amazon.com/Fluke-TP40-Automotive-Back-Probe/dp/B000VRJGT8
  19. Does the OP mean a NC type only? In that case...

    Does the OP mean a NC type only? In that case the Extech DVA30 but no Fluke.
  20. The Fluke T+Pro starts with at 12V LED indicator...

    The Fluke T+Pro starts with at 12V LED indicator at the low end.
  21. Well, you see it all the time, what's the first...

    Well, you see it all the time, what's the first thing people do these days when they see something happening? Pull out their cellphones and record it. To each their own!
  22. I wouldn't be talking about dumping oil in the...

    I wouldn't be talking about dumping oil in the trash if I were you, although you'd have to be caught in the act. A quick search finds in Texas, a fine between 1,000 and $50,000 and up to five years...
  23. I had a Fluke T5-600 read like 80VAC on a Lennox...

    I had a Fluke T5-600 read like 80VAC on a Lennox electronic filter where a Fluke True RMS read 120VAC. I even put a scope on it to see how distorted the sine wave and it wasn't that much but enough...
  24. Replies
    17
    Views
    1,463

    Try this site which has headlamps and flashlights...

    Try this site which has headlamps and flashlights that use the 18650 cells: http://www.fenix-store.com/18650/
  25. Replies
    28
    Views
    1,881

    The Fluke T5 is located in the electrical tester...

    The Fluke T5 is located in the electrical tester section at Fluke's own site so calling it a meter is a real stretch. I have a T5-600 also and I think the first Fluke product I ever purchased but I...
  26. Thread: Fluke Microamps

    by wptski
    Replies
    29
    Views
    2,937

    There are some clamp meters that have low input...

    There are some clamp meters that have low input impedance but not enough to eliminate stray voltage yet they claim to.
  27. Thread: Fluke Microamps

    by wptski
    Replies
    29
    Views
    2,937

    Bingo! Amprobe is the one. I'm a Flukee myself.

    Bingo! Amprobe is the one. I'm a Flukee myself.
  28. Thread: Fluke Microamps

    by wptski
    Replies
    29
    Views
    2,937

    Meterman was one of the companies that Fluke...

    Meterman was one of the companies that Fluke acquired some years ago. There's another well known name that I can't think of at the moment.

    Raytek is one but that's further back actually before...
  29. Not FPE's but............ ...

    Not FPE's but............

    http://img.photobucket.com/albums/v373/wptski/Cottage/IMGO.jpg
  30. Replies
    16
    Views
    1,766

    Spot welded pigtail on compressor overload had a...

    Spot welded pigtail on compressor overload had a high resistance causing the OL to open/close every few minutes. Wires were melted together.
    ...
  31. Replies
    17
    Views
    1,989

    As the YJ video on vacuum gauge usage states, you...

    As the YJ video on vacuum gauge usage states, you should "try" to keep your gauge point up somewhat to keep the possibility of getting oil in to a minimum.
  32. Thread: MEGGGGGAOHM

    by wptski
    Replies
    15
    Views
    2,097

    A bit dated but this is good reading:...

    A bit dated but this is good reading: http://www.biddlemegger.com/biddle/Stitch-new.pdf
  33. Replies
    1,065
    Views
    110,272

    Nope! I should have explained further as what...

    Nope! I should have explained further as what the unit can do or be used for. It has a USB port and only supplies 1A to it which can be used to charge a device.
  34. Replies
    1,065
    Views
    110,272

    The portable 5V power supplies are normally...

    The portable 5V power supplies are normally limited more than that. That's because they use the full sized or mini-USB port. I have a RavPower WiFi HD which has a 3,000 mAh battery but only...
  35. Replies
    1,065
    Views
    110,272

    I'm not a teacher so don't get all defensive. I...

    I'm not a teacher so don't get all defensive. I have an option as you do. I have Schulz's isl 6 Chameleon, Electrifly Triton and a IntelliPeak ICE. That site is down but I found what your using.
    ...
  36. Replies
    7
    Views
    987

    It's still a manual correct? Here's a PDF:...

    It's still a manual correct? Here's a PDF: http://www.getzebra.com/prodimages/VZManEng.pdf
  37. Replies
    7
    Views
    987

    Don't you have an instruction manual?

    Don't you have an instruction manual?
  38. Replies
    6
    Views
    953

    I've never measured the battery when the icon is...

    I've never measured the battery when the icon is flashing but a good 9V battery should check at 9V.
  39. Replies
    6
    Views
    953

    At the point that the low battery icon is...

    At the point that the low battery icon is flashing or comes up.
  40. Replies
    7
    Views
    987

    There's a few on YouTube like this one:...

    There's a few on YouTube like this one: https://www.youtube.com/watch?v=hOPhTgDR65Q which will bring up more to select from.
  41. Replies
    1,065
    Views
    110,272

    I have three RC type chargers and can charge a...

    I have three RC type chargers and can charge a Li-Poly properly but I use a purchased Battery Bunker on them. There's a difference between a Li-Ion and Li-Poly cell, the latter need special...
  42. Replies
    1,065
    Views
    110,272

    It'll work but for how long being much less...

    It'll work but for how long being much less capacity than "AA" cells?
  43. Replies
    11
    Views
    859

    Not really if any of their DMMs have an offset. ...

    Not really if any of their DMMs have an offset. I have two 54-II's which naturally do.

    EDIT:
    The 289 does have an offset. I have an old 279, IIRC it also has that but I maybe wrong.
  44. Replies
    11
    Views
    859

    As far as I know, nope!

    As far as I know, nope!
  45. Replies
    1,065
    Views
    110,272

    IIRC, Jim stated that the iManifold uses six...

    IIRC, Jim stated that the iManifold uses six cells in sets of three wired in parallel so that "could" be as high as 6,000 mAh depending on the cells used. Can you get a "proper" higher rated LiPo to...
  46. Replies
    1,065
    Views
    110,272

    Ni-MH cells lose their punch as well in cold...

    Ni-MH cells lose their punch as well in cold weather that's why RC car racers use warming packs.
  47. Replies
    62
    Views
    5,740

    Yeah it's in the Play Store but must be fussy...

    Yeah it's in the Play Store but must be fussy about the OS as it claims Android 4.0 and up but shows not compatible on my tablet with >4.0 custom ROM. The iManifold app installs at least on it....
  48. Thread: Appionwashers

    by wptski
    Replies
    5
    Views
    593

    You'll swear that the upper one is the wrong size...

    You'll swear that the upper one is the wrong size or too big but some poking/pushing will get it uncurled. True a dentist's pick is nice for popping them out but that's about it. If you compare new...
  49. Replies
    62
    Views
    5,740

    The YJ 67002:...

    The YJ 67002: http://www.hvacpw.com/Yellow-Jacket-67002-ManTooth-Dual-Pressure-Wireles-p/rit67002.htm

    The YJ 67001:...
  50. Replies
    45
    Views
    2,841

    I had a job after coming out of the Navy in 1965...

    I had a job after coming out of the Navy in 1965 at 21 years old where punch cards were used to monitor parts inventory system, high tech in those days. I handled the parts not the punch cards.
Results 1 to 50 of 987
Page 1 of 20 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech365 Virtual Event