Search:

Type: Posts; User: gregp

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Thread: oil burner parts

    by gregp
    Replies
    2
    Views
    120

    Sorry, should have mentioned. Residential only.

    Sorry, should have mentioned. Residential only.
  2. Thread: oil burner parts

    by gregp
    Replies
    2
    Views
    120

    oil burner parts

    I have a slew of oil burner parts (i.e. motors, pumps, controls) I am looking to unload at greatly reduced prices. All parts are new and in original boxes. E-mail me if interested and I will send you...
  3. The sad part is there are more out there that are...

    The sad part is there are more out there that are worse. With a little more training and education, he could prove to be a good service tech. You have to applaud is effort, he never gives up. Even...
  4. Must be out in Area 51. I don't see a thing

    Must be out in Area 51. I don't see a thing
  5. Did he say he would come back and at least look...

    Did he say he would come back and at least look at it?
  6. Have you contacted the installing contractor and...

    Have you contacted the installing contractor and asked them to come back and check it for you?
  7. Replies
    5
    Views
    242

    check your coil model #. The TXV might be already...

    check your coil model #. The TXV might be already installed on the coil
  8. Replies
    4
    Views
    253

    The CH33 can be installed with piston or TXV

    The CH33 can be installed with piston or TXV
  9. Replies
    3
    Views
    296

    Start moving wires around and you're sure to fry...

    Start moving wires around and you're sure to fry something. DIY advice is not permitted here. It could be a very simple fix, but you should call a pro. Changing parts and wires will just cost you...
  10. Replies
    27
    Views
    5,193

    AKA the double hung zone valve

    AKA the double hung zone valve
  11. Unfortunately, DIY advice cannot be given...

    Unfortunately, DIY advice cannot be given according to the rules of the forum. A separate control/relay MAY need to be installed. Call a pro and have them take care of this for you.
  12. Replies
    4
    Views
    310

    Wasn't the part covered under warranty? May want...

    Wasn't the part covered under warranty? May want to call another Carrier dealer that is more familiar with the Infinity system and get a 2nd opinion.
  13. Replies
    9
    Views
    1,682

    I would. I'd touch it long enough to throw it on...

    I would. I'd touch it long enough to throw it on the back of the truck to haul it away!
  14. Thread: Heatilator ser #

    by gregp
    Replies
    2
    Views
    695

    Thank you for your quick response. It is a choice...

    Thank you for your quick response. It is a choice between two valves, pre and post 18/02. The service tech did not get me the #'s you are referring to. Hopefully tech service can help me on Monday.
  15. Thread: Heatilator ser #

    by gregp
    Replies
    2
    Views
    695

    Heatilator ser #

    How do I tell the date of manufacture from the serial # GA886415. I need to know so I can get the part # for the gas valve.
  16. I questioned this a while back and was told that...

    I questioned this a while back and was told that if any water drips from the pipe and freezes, then someone slips and falls, the homeowner is liable. We found another way to vent the flue so it...
  17. These units do not require a trap in the drain....

    These units do not require a trap in the drain. The coil is above the blower.
  18. Thread: Thermostat power

    by gregp
    Replies
    9
    Views
    882

    Yes, this is DIY and any replies regarding...

    Yes, this is DIY and any replies regarding troubleshooting are against the rules. Sorry.
  19. Replies
    64
    Views
    6,937

    As was said, each company has their way of doing...

    As was said, each company has their way of doing business. The Goodman warranty covers the part and the labor to install the part. They do not pay for diagnostics, travel, etc. Some companies do not...
  20. Replies
    18
    Views
    5,382

    The Buderus is a 3 pass boiler, very efficient....

    The Buderus is a 3 pass boiler, very efficient. As was said earlier, service friendly easy to get to the flue passages with the swing-out door. If you notice, you cannot buy a European boiler with a...
  21. Replies
    18
    Views
    5,382

    If this is a hot water boiler (not steam) I would...

    If this is a hot water boiler (not steam) I would be looking at Buderus. If you currently have a domestic coil in the boiler, I would be looking at installing an indirect water heater as well.
  22. Replies
    20
    Views
    4,492

    Yeah, it could just be an old wall switch. I had...

    Yeah, it could just be an old wall switch. I had a similar problem. Bought a new $5 wall switch and hooked it up. Problem solved. Standard wall switches tend to develop resistance over time. You...
  23. Replies
    1
    Views
    615

    The

    air handler is 1998. They may or may not have the heater available anymore. Your contractor will have to check with the distributor for that air handler. He will also have to detemine by heat loss...
  24. Replies
    6
    Views
    596

    It is

    HIGHLY unlikey you damaged the braze joint. You would have probably heard a hissing noise if that was the case.
  25. Replies
    6
    Views
    606

    What does

    your contractor/hvac company say regarding this?
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event