Search:

Sorry , I am still a bit new and now realize that this discussion is a violation so I will not respond to it again. I see that some from the website have responded also. It is a good discussion...

There is not much science in Darwinism. It was just his opinion. There is no link between apes and humans. It's never been found and won't be because they were created differently the same as...

If it gets down to _20f .. you probably don't have a refrigeration problem , but rather a control probelem. Thermostat sticking, defrtost timer sticking, defrost termination sticking,loose wire,...

Mostly about the experience of Coolwhip:

Good discussion here, Probably could take several volumes to work it out.

There is a big problem here that goes on everywhere...we set our eyes on...

Thanks for the encouragement and I think r134a will give me the temperatures that I want. I have a preliminary drawing of what I will build.
I can see since they have made heatpump domestic...

I want to replace a 96kbtuh lp gas boiler with my own home built heatpump.
I don't know how to engineer this and need some help. The water loop to heat concrete pads that hogs lie on needs to be...

sounds like a leak between the inner and outer

try this : http://kitchen.manualsonline.com/manuals/mfg/hobart_corp/hobart_corp_dishwasher_product_list.html


just google it .

sorry you probably have finished this project but here is...

I Think The Heat Strip Resembling Coils Are A Way To Cause Reduced Voltage For Starting. Sometimes On Older Motor Control Systems They Were Used For Dynamic Braking.

If You Look At The Motor Circuit With The Y Contactor Only You Will See That The Circuit Is A Y Circuit. When The Shorting Contactor Closes The Circuit Becomes A Delta Circuit. I Forget Some Of The ...

common problem. yse you have to condition make up air most of the time unless you can control the path of the make up air and get all of it to go out the exhaust without crossing the conditioned...

I read a reply that sai be sure to use hi emp...... What is important is the tightness ( is that a word) of your connections not the wire or the terminals. I have seen the cheap aluminum terminals...

call your tech guy at the manufacturer that your local supply house carries in stock. he'll help you.

My son said that he sw a demonstration using copper tubing that blew away the hose performance. I agree to use analogue not digital micron gauge and u need to learn how to use the gauge. experiment...

If I don,t find the leak quickly I use the flourescent dye right away. Why would manufacturers approve it if it wasn't checked out by them ? The dye will not travel where the oil does not circulate....

Go for it Dan, but be prepared for some difficult lessons. i have successfully waded through nearly every service call by learning it as i go. use manufacturers 800 tech line if you need help on...