Search:

Type: Posts; User: Todd Whaley

Page 1 of 15 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    11
    Views
    699

    You can't?

    You can't?
  2. Thread: WOW

    by Todd Whaley
    Replies
    23
    Views
    3,544

    571771 Pro Diy..... Also had a shop vac hose...

    571771 Pro Diy..... Also had a shop vac hose condensate line extension, "Froze"
  3. Replies
    23
    Views
    1,040

    Just finished servicing one..... leaking in...

    Just finished servicing one..... leaking in coil..... of course. Petition to make a new category. TECH TO TECH GOODMAN CHAT residential and pro. Heh
  4. Put meter on tone and run the hose.

    Put meter on tone and run the hose.
  5. The ever mangled evap door with a roll of mastic...

    The ever mangled evap door with a roll of mastic applied. In-laws have two split hp's 2009 vintage. One copper, one aluminum. Copper leaking.....
  6. Replies
    15
    Views
    1,505

    Yeah they are proud of their parts, "price wise"....

    Yeah they are proud of their parts, "price wise". For me that setup was a nightmare of confusion due to my lack of experience with older controls. My original question was me reading the schematic...
  7. Replies
    15
    Views
    1,505

    Unit still going a year in. I snipped the...

    Unit still going a year in. I snipped the resistor on the 20mfd cap and put in parallel with the 7.5mfd. I dont want to pay for a 27.5/5 dual run. Not using the trickle method, but found a belly...
  8. Replies
    744
    Views
    146,473

    Yup thats it. But this one is vertical through...

    Yup thats it. But this one is vertical through roof.
  9. Replies
    8
    Views
    680

    G61MPV?

    G61MPV?
  10. Replies
    744
    Views
    146,473

    Concentric..... Help me understand a 90% in an...

    Concentric..... Help me understand a 90% in an attic. Exhaust and supply together at a Y exiting roof. Is it double walled at the joint?
  11. Replies
    744
    Views
    146,473

    Good one yesterday. Heat tune up on a Carrier...

    Good one yesterday. Heat tune up on a Carrier 90. 45 degrees in house. Propane dead empty, and a busted heat exchanger. Rollout switch had been bypassed at one time, and flame burning hole...
  12. Replies
    20
    Views
    1,460

    Is it satisfying stat in 2nd stage, or dropping...

    Is it satisfying stat in 2nd stage, or dropping out on second stage then failing to re-lite? Cleaned inducer port? T into pressure switches? Sometimes stat wire is not enough to get all deposits...
  13. Renters and filters.....

    Renters and filters.....
  14. Replies
    25
    Views
    3,248

    Asbestos tape? Have been to a few of these. ...

    Asbestos tape? Have been to a few of these. Luckily the filters are just as bad.
  15. Replies
    81
    Views
    7,091

    Fluke 116 combo, fieldpiece, and a screwdriver...

    Fluke 116 combo, fieldpiece, and a screwdriver for backup.
  16. Replies
    57
    Views
    5,623

    Form over function.

    Form over function.
  17. Replies
    57
    Views
    5,623

    The one nest I ever torched was on a carrier gas...

    The one nest I ever torched was on a carrier gas furnace horizontal. Pressure switch leads sandwiched against the metal box the power comes in through. With some fine needle nose work I shorted...
  18. So not a SLP98?

    So not a SLP98?
  19. Replies
    8
    Views
    469

    most no-heat call I go to have clean filters ...

    most no-heat call I go to have clean filters :whistle:
  20. Replies
    44
    Views
    2,717

    Maybe they are needed for more severe operating...

    Maybe they are needed for more severe operating conditions, a more robust and reliable design for ambient conditions, but im sure there will be an answer coming that is spot on.
  21. Replies
    44
    Views
    2,717

    Let me be the first to say I dont know. Did have...

    Let me be the first to say I dont know. Did have a sparker shorting out on the housing one time failing to ignite.
  22. Replies
    56
    Views
    7,297

    Very nice. I do have a Bluetooth obd2 scanner...

    Very nice. I do have a Bluetooth obd2 scanner that stays plugged in. Have an app on the tablet that warns me of code faults before they turn on the light. Also real time instrument cluster...
  23. Loose or missing grommets in between blower...

    Loose or missing grommets in between blower housing, or blower removal rubbing over wires. I think its a carrier that used to mount pressure switch sandwiched on power supply cover. Learned that...
  24. Replies
    64
    Views
    3,197

    I did confirm a high limit shutdown yesterday. ...

    I did confirm a high limit shutdown yesterday. It was a 90 day media filter going on a year. Heh
  25. Replies
    64
    Views
    3,197

    Have extra motors on hand. Lol

    Have extra motors on hand. Lol
  26. Replies
    64
    Views
    3,197

    Capacitor sizing and parallels are good. Low...

    Capacitor sizing and parallels are good. Low Voltage during particular hp operation. Whats a relay and how can I avoid learning them. The capacitor will not fit in the provided strap, use tape,...
  27. Replies
    56
    Views
    7,297

    No injuries. Wet, dark, very sharp corner. ...

    No injuries. Wet, dark, very sharp corner. Went into ditch pitched left rolled onto side and slid to a stop. Two wreckers had to pull it up and out in unison. State trooper said I exceeded a...
  28. Replies
    56
    Views
    7,297

    I rolled my transit connect in a ditch. Fun call...

    I rolled my transit connect in a ditch. Fun call to fleet service.
  29. Replies
    14
    Views
    2,332

    my 760 is installed as manufacturer recommends,...

    my 760 is installed as manufacturer recommends, but what happened when the t-former on the board failed? I had to get creative with controls.
  30. Replies
    9
    Views
    966

    Ss2 seems to be our go to. The only time I see...

    Ss2 seems to be our go to. The only time I see problems is when installers put them in improperly.
  31. I had to contact manufacturer to see the ohm...

    I had to contact manufacturer to see the ohm value should be to the corresponding oat. Lennox thing....
  32. get your post count up and apply for pros status....

    get your post count up and apply for pros status. Cannot give detailed technical support out in open forums.
  33. Are you going to feed 24v to the 700?

    Are you going to feed 24v to the 700?
  34. Replies
    21
    Views
    1,214

    Usually find them where they are zip tied to the...

    Usually find them where they are zip tied to the copper. Found one where guys putting up a radient barrier pierced the t-stat wires. I had to remove alot of it.
  35. Replies
    8
    Views
    357

    Tighten everything.

    Tighten everything.
  36. Replies
    15
    Views
    757

    Well its laryngitis. First doc gave me amox to...

    Well its laryngitis. First doc gave me amox to treat a virus.....nice. second doc said, "we are gonna give you strong cough syrup since hacking your guts up wont help inflammation". They took...
  37. Replies
    15
    Views
    757

    Required PPE yes. In truck, No. I have a loaner...

    Required PPE yes. In truck, No. I have a loaner truck right now, so kinda my fault. I did wear during duct installs and cleans.
  38. Replies
    15
    Views
    757

    Web MD has the audacity to list Anthrax as the #2...

    Web MD has the audacity to list Anthrax as the #2 possible cause.... HA!
  39. Replies
    47
    Views
    3,007

    Bats on the id coil. Decomposed. HO said there...

    Bats on the id coil. Decomposed. HO said there was an odd smell over the summer. I thought it was insulation when I retrieved it. Ugh.
  40. Feel you pain with Lennox.

    Feel you pain with Lennox.
  41. Replies
    15
    Views
    757

    strange illness

    Well I started with a severe cough leading to inflammation of the vocal cords. No other symptoms. Now a week later cough persists, very little chest congestion, low grade fever, fatigue, body...
  42. Replies
    16
    Views
    1,073

    No not aluminum. Over the summer I ran many...

    No not aluminum. Over the summer I ran many calls 1st year on rheem packs.
  43. Replies
    17
    Views
    3,592

    Had a carrier pack yesterday with Swiss cheese...

    Had a carrier pack yesterday with Swiss cheese HX. Priced repairs, out of warranty, HO wanted me to weld it up. 99 pack, recommended replacement, have not heard back. Would like to know what he...
  44. Replies
    6
    Views
    1,792

    Mighty putty.

    Mighty putty.
  45. Replies
    17
    Views
    3,592

    Bypassed door switch. Classic. I actually raid...

    Bypassed door switch. Classic. I actually raid the scrap pile for those things just in case they are missing, but they usually turn up near the unit. Underneath....
  46. Replies
    26
    Views
    2,924

    Have a lady with a Lennox pure air kit who has to...

    Have a lady with a Lennox pure air kit who has to change it every six months. Suck it up and smoke outside. Too expensive to change that frequently.
  47. Replies
    16
    Views
    1,073

    leakers+txv+x13=ugh :gah:

    leakers+txv+x13=ugh :gah:
  48. Replies
    53
    Views
    4,207

    Auto changover on a second floor breezeway. Gas...

    Auto changover on a second floor breezeway. Gas logs. You know where this is going
  49. Replies
    53
    Views
    4,207

    yup. done that.

    yup. done that.
  50. Replies
    30
    Views
    2,133

    It's one of those units that defy logic and...

    It's one of those units that defy logic and reason. More the reason to keep her running. Is that some kind of Carrier?
Results 1 to 50 of 743
Page 1 of 15 1 2 3 4

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech365 Virtual Event