Search:

Type: Posts; User: under pressure

Page 1 of 7 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: veto

    by under pressure
    Replies
    9
    Views
    1,104

    I carried a open pouch for many years... I...

    I carried a open pouch for many years... I changed when I emptied it onto a group of workers below while climbed down a roof hatch ladder...
  2. Dang!!! Sent through Tapatalk, even though...

    Dang!!!


    Sent through Tapatalk, even though they ruined it with "upgrades"...
  3. Replies
    38
    Views
    1,044

    Another thought that entered my mind was to...

    Another thought that entered my mind was to create a curiosity situation whereas a dome light left on in a car with enough light to illuminate whoever's Face was pressed against the glass looking in...
  4. Replies
    38
    Views
    1,044

    Night vision security cameras

    I wonder if a touch lamp technology type switch could be powered from an inverter and a relay wired directly to the horn to be set up where the entire car body is the touch the surface? Not...
  5. Replies
    9
    Views
    540

    If one of the clips holding in the pie slice were...

    If one of the clips holding in the pie slice were to pop open, I would hate to be the one there to have to fix it if it were spinning reversed...
  6. Replies
    54
    Views
    6,198

    In a pinch, you could always use the poor man's...

    In a pinch, you could always use the poor man's low loss fitting..... Crush the hose as close to the fitting as you can with your linesman pliers to stop the hose from adding to the problem by...
  7. Replies
    54
    Views
    6,198

    Your post that you shared, made me go buy another...

    Your post that you shared, made me go buy another pair of thick rubber impervious gloves… The right glove since I'm right-handed,Will stay in the meter section of my Vito bag under my meters so that...
  8. Replies
    13
    Views
    610

    It's not plan "A" Sent through Tapatalk,...

    It's not plan "A"


    Sent through Tapatalk, even though they ruined it with "upgrades"...
  9. Replies
    16
    Views
    638

    Two pinch off tools??? Sent through...

    Two pinch off tools???


    Sent through Tapatalk, even though they ruined it with "upgrades"...
  10. Replies
    54
    Views
    6,198

    Sorry about your hand… What kind of glove where...

    Sorry about your hand… What kind of glove where you wearing???


    Sent through Tapatalk, even though they ruined it with "upgrades"...
  11. Replies
    6
    Views
    866

    Gone tomorrow... Sent through Tapatalk, even...

    Gone tomorrow...


    Sent through Tapatalk, even though they ruined it with "upgrades"...
  12. Replies
    52
    Views
    5,399

    Is the dog even on a leash??? Sent through...

    Is the dog even on a leash???


    Sent through Tapatalk, even though they ruined it with "upgrades"...
  13. Replies
    36
    Views
    2,959

    Since we are over thinking this, I always take my...

    Since we are over thinking this, I always take my Sheaves to a machine shop and have them turned and trued before attempting to align them. I only use Machinist's grade string and double check with a...
  14. Can you get store manager to provide the contact...

    Can you get store manager to provide the contact # ???
  15. Replies
    36
    Views
    2,959

    Scott, I interpreted the string reference takes...

    Scott, I interpreted the string reference takes the place of a straight edge… In the diagram it appears it is secured to the shaft first and then wrapped around the outer edge of the pulley to start...
  16. Are they next to the Hack Saws? They are hack...

    Are they next to the Hack Saws? They are hack tools...
  17. Replies
    50
    Views
    7,662

    CMS??? Sent through Tapatalk, even though...

    CMS???


    Sent through Tapatalk, even though they ruined it with "upgrades"...
  18. I agree with coolwine...even the best of them are...

    I agree with coolwine...even the best of them are mediocre for each individual tool, I keep one in my tacklebox but don't know why… I started rethinking carrying conductive tools the day I...
  19. Replies
    8
    Views
    651

    Should you turn off the water at meter until you...

    Should you turn off the water at meter until you know the situation???
  20. At the end of the month Will Smith will blind you...

    At the end of the month Will Smith will blind you with the little black pen to erace the memory of that horrible looking beast???


    Sent through Tapatalk, even though they ruined it with...
  21. Replies
    13
    Views
    611

    Listened to the second one while muted… Not bad ...

    Listened to the second one while muted… Not bad


    Sent through Tapatalk, even though they ruined it with "upgrades"...
  22. I tried to dry out a vintage Mickey mouse watch...

    I tried to dry out a vintage Mickey mouse watch in a peanut butter jar with a Schrader fitting soldered to the top and hooked to my vacuum pump…....I witnessed the Crystal exploding off of the watch...
  23. Let's all hope that the terrorists "Mark" man...

    Let's all hope that the terrorists "Mark" man ship isn't that good......


    Sent from my iPhone using Tapatalk
  24. Replies
    17
    Views
    1,261

    Batteries for flashlights and Meters are a cost...

    Batteries for flashlights and Meters are a cost of doing business....................... Do you work for CMS???

    http://hvac-talk.com/vbb/showthread.php?1060241-CMS-Mechanical-Services
  25. standing pilot furnaces in tight places that...

    standing pilot furnaces in tight places that failed to immediately ignite .....scrambling to turn the gas off while listening to that baby exhale like a sucker punch to the abdominal cavity .....
    ...
  26. Replies
    0
    Views
    375

    yes dear .....

    I was sitting here in my van minding my own business ,when Mama and baby walked around the corner .....I spooked them when I raised my camera to take the shot.... they separated and ran into...
  27. Google the part # and see where it takes...

    Google the part # and see where it takes you.............
  28. I have heard flexible gas whips make a crazy...

    I have heard flexible gas whips make a crazy noise when a high volume of gas is passing through it ......

    Sent from my PC36100 using Tapatalk 2
  29. Receiver on 5 ton Heat Pump? Anyone ever seen this???

    I was working at a site where I maintain a few Chillers and went back to their shop to Eat Lunch. While there, Noticed someone in Maintenance was swapping out a Dry R22 Heat pump that cools the Shop...
  30. Wind up Robinaire temp. & humidity Recorder with...

    Wind up Robinaire temp. & humidity Recorder with paper chart.....the Origional data logger...

    Sent from my PC36100 using Tapatalk 2
  31. r12 was cheaper than a flat tire repair .... ...

    r12 was cheaper than a flat tire repair ....

    Sent from my PC36100 using Tapatalk 2
  32. Black Analog Amprobe.................. the fancy...

    Black Analog Amprobe.................. the fancy one had a Ohm scale...
  33. useful post: ... almost want to order a...

    useful post: ... almost want to order a replacement card and keep it in my safe ...

    Sent from my PC36100 using Tapatalk 2
  34. Replies
    31
    Views
    3,793

    nevermind the photos of the joints , I want to...

    nevermind the photos of the joints , I want to see the photos of the wall cavity that was being soldered in.............

    Sent from my PC36100 using Tapatalk 2
  35. Replies
    38
    Views
    5,161

    Back in the 1980's I was. volunteer firefighter ....

    Back in the 1980's I was. volunteer firefighter .
    I remember entering a working house fire trying to knock down the living room ,where most of the fire was .... the heater closet was in the...
  36. Replies
    15
    Views
    882

    whenever I find a nest around my house ,I go...

    whenever I find a nest around my house ,I go fetch my .22 caliber Benjamin pellet rifle and a couple of beers ...depending on what's behind the nest ,and whether or not the pellets will damage it...
  37. Replies
    23
    Views
    1,508

    I was asked to work on a clamshell Grill once...

    I was asked to work on a clamshell Grill once ....I asked the manager when it was going to be turned off and allowed to cool down ,he replied ....they always work on it while we're using it ....I...
  38. Replies
    39
    Views
    1,947

    NICE!!!!!!!!!!!!

    NICE!!!!!!!!!!!!
  39. Replies
    39
    Views
    1,947

    Are Segways easy to...

    Are Segways easy to operate???......................................lol
  40. Replies
    39
    Views
    1,947

    Now that was Funny!!! About have those folks...

    Now that was Funny!!! About have those folks got slide rulers and pocket protectors for gifts growing up or were never invited to the Reindeer Games.... All the Mall Cop positions were filled, so...
  41. Replies
    17
    Views
    1,437

    Hope ya offered that Fella a cold...

    Hope ya offered that Fella a cold drink........lol
    Sounds like a happy outcome.....
  42. Replies
    17
    Views
    1,437

    can you post a photo of the cover ???...it is my...

    can you post a photo of the cover ???...it is my guess that your exhaust is not designed for high-temperature ventilation and you are cooking the motor due to the hot environment it is in ...
    ...
  43. Replies
    3
    Views
    516

    Did you get a pic of All those...

    Did you get a pic of All those relays???.......................................lol
  44. Replies
    39
    Views
    1,947

    not sure I would have used your choice of words...

    not sure I would have used your choice of words about venting ...I would have implied you were using your finest recovery rag to later be wrung out in the proper receptacle ....lol

    but to answer...
  45. Replies
    38
    Views
    2,448

    My reply was aimed at this comment. On a typical...

    My reply was aimed at this comment. On a typical PM on a residential customer, if I could drag my index finger across the inside curve of a couple of blades and have nothing other than light powder...
  46. Replies
    38
    Views
    2,448

    back when I used to pull and clean a bunch of...

    back when I used to pull and clean a bunch of them doing residential p.m. Work , I took a one gallon plastic coil cleaner jug ,cut the bottom out of it and cut half of the side out of it so it looked...
  47. Replies
    16
    Views
    1,141

    in my early days ,I had the refrigerant out of a...

    in my early days ,I had the refrigerant out of a system like that to repair a leak ...I "cleaned up " the sloppy installation and removed that unsightly coil of tubing left in the return air plenum...
  48. Replies
    28
    Views
    2,483

    A pressurized ( Well Pump) water tank will...

    A pressurized ( Well Pump) water tank will accomplish what you are trying to do. I used to carry a 30 gallon pressure tank to remote equipment sites for the same reason. You charge it with a garden...
  49. Replies
    11
    Views
    2,287

    It may have been the last guy to service it that...

    It may have been the last guy to service it that wizzed on it....

    Sent from my PC36100 using Tapatalk 2
  50. Replies
    57
    Views
    9,824

    is it hooked up to a downflow AHU? Sent from...

    is it hooked up to a downflow AHU?

    Sent from my PC36100 using Tapatalk 2
Results 1 to 50 of 325
Page 1 of 7 1 2 3 4

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event