Search:

Here is what I could come up with a quick search

All the Trane binarys are a 2 part SNVT. they require a true/false and also a %. You could write the % to 100 all the time and switch the binary on/off and it would accomplish the task.

My email address is in my profile :)

Sent to you too :)

coming to you!

Send me your email. I can get you the Range and offset calculator and any IOMs you need

You are correct. I wasn't thinking about the difference in static tubes and pitot tubes. I have both and use the static tip if I only need static pressure.

I would use the pitot tubes to take the measurements with. If you insert a tube into the duct, you can get different readings when the tube is in different positions due to the velocity pressure of...

I have a job that has 18 generic VAV boxes with the Trane VV551 VAV retrofit controllers. We used a 3rd party to integrate them into the JACE that is installed on the campus of my customer. The...

I was just talking to one of my co workers this morning about that. He said the valves have been redesigned and the replacement won't work with the old chiller module that controls the...

Try BAS-SVX17B-EN.
I can e-mail it to you if you can't find it. That may be the one you are looking for.

If the sensors are out of calibration, just replace them. They cost about $10 each. that is way less than the cost of the Rover service tool.

What is wrong with it?

There are configurations and programs that will have to be downloaded into the new PCM. You will also need the program to set it up. If you happen to have copies of the old programs, you are good. If...

Go into the setup menu and enable tracer control. then you should be able to select tracer as a setpoint source.

I did some searching, and cannot find where It was mentioned. I'm sorry I thought I had posted a reply.
If time permits, I'll make a couple calls today and inquire about it to some of the guys that...

I think it can be done, but that is a lot of work. I will check around today and see if I can find some service bulletin or something like that that mentions the 580 being seen as a GLD.

I can't see any newer revisions of V15 SP1 on the website. It seems like one version of summit brought in the MP580/581s in as a GLD.
Have you tried reverting the firmware in the 580 to an earlier...

OA sensor is behind the mist eliminators / louvers at the back of the rtu in the outside air intake section. Evap sensor should be mounted to the suction line in the location sgraefe said.

Are you looking to run your own business or get hired by a "local" contractor? We have a large contract at Ft. Benning and need additional men. Most of it is chillers, cooling towers, and a few...

You're welcome. :)

Welcome! Good luck finding the issue.

I use a combination of a DP airflow switch and an Adjustable CT. When setting up the drive, I adjust the CT to pull in when the VFD reaches the current the motor is pulling when at minimum frequency....

Check your e-mail

Here are some service manuals.Hopefully they will help