Search:

It's not unusual to get a slight smell of gas in that area if the furnace has recently been operating, especially with the panel removed. There is a small amount of gas inside the manifold that can...

XC14 is from the Elite (mid) line. Look at the SL280V furnace.

I generally use the eccentric termination kit. Only one wall penetration. I would agree that a nice air cleaner would have been a nice add on to that G71. Also, I don't see a vent tee on the furnace...

I don't think that Lennox match up you listed will make the tax credit either. Looks like 17.2 SEER and 12.70 EER.

Amazing isn't it? Scales certified by the federal government is required for selling hamburger, but not for refrigerant that sells for 10-20 times the per pound cost.

I use a digital scale anytime...

http://www.homeenergy.org/archive/hem.dis.anl.gov/eehem/95/950904.html

Looked like old info to me as soon as I opened the doc.

Call the installing contractor and ask if there were trunk dampers installed.

Thanks for the clarification. This coil # doesn't exist however, and the SEER rating still isn't 19 even with a matched coil as the OP believes. I think a little more homework is in order.

The coil model # makes no sense. I don't believe it's 19 SEER. Otherwise I do believe the XP19 and G71 MPP would make an excellent system.

Make the call. The sooner the better. Refrigeration systems absolutely hate being left open to the atmosphere. And DONT start the system until the repair is made.

Merit and Elite products now qualify for free extended parts warranties through 10 yrs. 7/8 vapor line on all R410A systems? Haven't heard of this.

14acx is builder grade not very quiet. XC13 and XC14 are both from the elite line and more quiet than the 14acx but not extremely quiet. XC15 is a very quiet unit and comes from the Dave Lennox...

There is a fitting made that I've seen that is a flat offset with round going in and coming out on the opposite end app.12" or so long that puts it past the dryer.

Call and discuss with the two your concerns. Too often customers are concerned about stepping on toes or hurting feelings. I'm sure they are both professionals and won't mind validating their...

Get referrals from friends and family. The professionals doing this work have tested, installed, repaired 1,000's more systems than CR.

I like the XP15 for quiet operation as well as the warranties. If I were in the market for 2 stage I would choose the XP19 over the XP16.

Sounds like you need to have it checked (best by someone else). If the balance point is set at 34, it should never see pressures low enough under normal operation to trip the LP switch. I still like...

Maybe he replaced a defective part and wants to bench test the part he removed. Is the system operating properly now?

Call your local building inspectors office and pose the question to them.

Auto setting allows the system to switch between heating and cooling without you changing the setting to 'heat' or 'cool'. Set them both at a temperature that is comfortable to you. The deadband...

The horizontal drain pan should have been removed per the installation instructions if the unit was installed in the upflow position. Mold loves growing in those locations. Possibly have the air flow...

No rebates on XC13 that I know of, but ask your contractor about the tax credits on qualifying systems.

That's not PVC pipe. It's a single wall vent connector (painted white) that's connected to a type B common vent. Your clearances are not allowable with single wall pipe. The single wall should be...

Those numbers look correct for zone IV.