Search:

Type: Posts; User: MICHAEL 4130

Search: Search took 0.01 seconds.

  1. Replies
    19
    Views
    1,159

    All air has been purged from system there are two...

    All air has been purged from system there are two TACOs 007's. there is a 1 in cross t with a 1/4 vent on top and boiler on the bottom. The other side of the t goes to the circulator return and...
  2. Replies
    19
    Views
    1,159

    I let the system cool down to 70 F . Valved off...

    I let the system cool down to 70 F . Valved off the water feed and released the pressure in the system. checked again and found the pressure to be 15 psi. thanks for the reply.
  3. Replies
    19
    Views
    1,159

    Any way to tell if the indirect water tank is...

    Any way to tell if the indirect water tank is leaking other than isolating the loop and pressurizing with nitrogen?
  4. Replies
    19
    Views
    1,159

    Thanks. I did check the pressure there is 30 psi...

    Thanks. I did check the pressure there is 30 psi in the tank. Never had a problem with the old 30 tank.
  5. Replies
    19
    Views
    1,159

    System has copper fin baseboard. this is a new...

    System has copper fin baseboard. this is a new problem on a existing system. The expansion tank is installed on the primary loop along with an air scoop and vent. Theres about 300 linear feet of 3/4...
  6. Replies
    19
    Views
    1,159

    What do you mean by post count up. And how do you...

    What do you mean by post count up. And how do you apply?
  7. Replies
    19
    Views
    1,159

    FRUSRTATED!

    I HAVE A WEIL MCLAIN GV-5 SERIES BOILER. THE PRESSURE RELIEF IS LEAKING. I HAVE REPLACED THE EXPANSION TANK NO. ET-30, 30 P.S.I PRESSURE RELIEF, AND THE AUTO FEED VALVE. THE PRESSURE SLOWLY RISES...
  8. Replies
    3
    Views
    597

    Down Flow Oil Fired Furnace.

    I'M LOOKING TO INSTALL AN A / COIL ON A DOWN FLOW SYSTEM. HAVE NOT SEEN IT IT DONE BEFORE. THE APPLICATION IS NOT YOUR ORDINARY HOME. DUCT WORK RUNS THROUGH A CEMENT SLAB AND UNDER THE HOUSE IN A...
  9. Replies
    6
    Views
    1,255

    Thanks I'll Give Scottsman A Call.

    Thanks I'll Give Scottsman A Call.
  10. Replies
    6
    Views
    1,255

    Poodle Head

    I Don't Quite Understand Your Question. The Motor And The Gear Reducer Are Connected. The Gear Reducer Is OfF Set From The Motors Drive Shaft By 5". The Unit Is Roughly 30" Wide.
  11. Replies
    6
    Views
    1,255

    Thank You.

    I Appreciate The Reply. I'll Contact The Distributors And Maybe They'll Be Some Help.
  12. Replies
    6
    Views
    1,255

    Crystal Tip, Iceomatic Help!

    TRYING TO LOCATE THE MOTOR AND GEAR REDUCER FOR THE IMPELLER ON A FLAKE ICE MACHINE. NO MODEL # IS AVAILABLE FROM THE MACHINE ITSELF. THE MAKE OF THE MOTOR IS BISON. I CONTACTED BISON THEY HAD TOLD...
Results 1 to 12 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event