Search:

Type: Posts; User: brettrobbins

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    28
    Views
    2,537

    Run the compressor with the blower motor off and...

    Run the compressor with the blower motor off and watch the distributor tube were the orfices are the ones that ice up are restricted the ones that don't are clear.


    Sent from my iPhone using...
  2. Replies
    11
    Views
    527

    Just from the info you gave I would say indoor...

    Just from the info you gave I would say indoor drier is plugged and system is overcharged.


    Sent from my iPhone using Tapatalk
  3. Replies
    19
    Views
    2,106

    These are apparently bad units, I take care of a...

    These are apparently bad units, I take care of a greenhouse with about 30 of these units barely a year old and I have had to replace multiple circuit boards and fan motors already. Both boards I...
  4. Replies
    2
    Views
    916

    That is what I found Honeywell had a stat with....

    That is what I found Honeywell had a stat with. Remote sensor that worked great thanks.
  5. Replies
    2
    Views
    916

    Chemical storage thermostat

    Looking for a thermostat to replace old 24v stat. Thermostat is mounted just on the other side of mason wall in electrical room, with a metal probe coming out the back of the t-stat box and sticking...
  6. Replies
    37
    Views
    2,501

    Install a new variable speed indoor unit with a 2...

    Install a new variable speed indoor unit with a 2 stage condensing unit. Leave zone dampers and bypass alone problem solved.
  7. Replies
    29
    Views
    2,302

    Installed just before the coil and txv will catch...

    Installed just before the coil and txv will catch any copper filings,solder or any debree so it does not get stuck in the txv hence the word filter in filter drier. If installed out by the condenser...
  8. Thread: New Car

    by brettrobbins
    Replies
    1
    Views
    1,091

    You have been watching to much tv over the...

    You have been watching to much tv over the holidays haven't you?
  9. Replies
    14
    Views
    1,301

    I have a Hilti that works great.

    I have a Hilti that works great.
  10. Replies
    6
    Views
    1,032

    At about 200degF they begin to fail depends on...

    At about 200degF they begin to fail depends on the bearing manufacture some are rated a little higher and some lower.
  11. Replies
    18
    Views
    1,541

    You will have to find the problem with the main...

    You will have to find the problem with the main supply fan ask for access to it and check if vfd is in hand mode and if not check transducer that controls vfd.
  12. Replies
    16
    Views
    3,670

    LDS Church info

    An interesting article written by Ford Motor Company for their employees
    from the 'Ford Interfaith' group as a message about the Church.
    The Ford Interfaith group promotes unity by sharing...
  13. Replies
    1
    Views
    468

    It is always fun to get new toys.

    It is always fun to get new toys.
  14. Replies
    8
    Views
    871

    Good way if you think your reading might be...

    Good way if you think your reading might be phantom voltage is to hook up a small light bulb between two jumper wires, or good meters have settings to block out phantom voltage.
  15. Replies
    20
    Views
    1,622

    There are some older units with double coils that...

    There are some older units with double coils that the only way to clean it is to pull the top and separate the coils or it all just ends up stuck between the two even if you clean from both sides.
  16. Replies
    11
    Views
    2,073

    It depends controls is a more specialized field...

    It depends controls is a more specialized field especially if you know the programming side and would not be susceptible to layoffs as much as service techs, there are alot of techs but not many...
  17. Replies
    2
    Views
    1,540

    I would just quote new units of the brand you...

    I would just quote new units of the brand you like and trust and size it to the space it is serving, original units might not have been sized right or derated correctly hence the cracked heat...
  18. Transformer feeds supply power straight to R...

    Transformer feeds supply power straight to R terminal not sure what diffence it would make.
  19. Replies
    6
    Views
    731

    I have never used them in a residential setting...

    I have never used them in a residential setting but for commercial buildings they are the best in my opinion, but they also no what they want for them $ that is my guess as to why they are not used...
  20. Replies
    24
    Views
    1,417

    Some techs I know tell them that they charge...

    Some techs I know tell them that they charge double for training, but if you are confident in your skills it should not be a problem just strike up a conversation and enjoy there company sometimes...
  21. Replies
    1
    Views
    331

    A/C Wizard for an IPhone.

    A/C Wizard for an IPhone.
  22. Replies
    28
    Views
    2,310

    I have a J/B vacume pump that workers great and I...

    I have a J/B vacume pump that workers great and I love the new Apion recovery machines small and fast as well.
  23. Replies
    7
    Views
    693

    Poll: Carrier/Bryant dealer is by far the best dealer...

    Carrier/Bryant dealer is by far the best dealer here in Utah.
  24. Replies
    44
    Views
    3,562

    I have a field piece that went out after a year...

    I have a field piece that went out after a year will only read amps now nothing else. I got a Fluke 116 and love it still use the Field Piece for amps.
  25. That looks great!!

    That looks great!!
Results 1 to 25 of 48
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event