Type: Posts; User: gmb
I have the same problem with mine, it's frustrating as hell!
I had one guy that wouldn't pay and I told him there was a list at the suppliers that all the contractors contribute to and that he was going on it and "good luck getting anyone else out to fix...
If duct sealer gets on your clothes they are ruined, may as well wear them whenever your duct sealing!
Their website shows examples of multi units being vented and it looks interesting
Has anyone used the poly pro venting system from Duravent? It says you can vent two appliances thru 1 pipe like b-vent but its 636 rated.
Wiss are definitely the standard, although I picked up some Milwaukee snips to try in the shop and they seem pretty good.
I recently installed a gas fireplace in a customers home and told them they would need an electrician to run power to the unit to operate the fan, and I also told him the stat wire coiled up on the...
I have it also, mine must be a lemon. Super loud and drains the battery in no time! Not happy with it at all.
Dirtbags stealing the tools a guy uses to provide for his family is pretty f*#king low!
Never heard of a builder over sizing equipment, under sizing to save a buck, heard that! He must have got a deal on the equipment!
The Milwaukee m12 set are great. I keep the impact one in my bag, it's small and has lots of power for its size
Quality work there!
Thats what I was told by a H.O when I went to a service call that had a frozen coil. Went to each return to check airflow had none, took off grille and cardboard was taped to the back, asked H.O...
usually you would insulate the ductwork before installing , and the duct size is increased to accommodate the insulation. Now you can only insulate what you can reach and have to use stick pins...
Reed tools make a system 636 tool kit that comes with a pipe cutter, de-burring and bevel tool, and a inside pipe cutter. Works really good!
I've worked for both and I preferred the small shops unless it was a family shop because when it got slow you were the first to go
I got an email the other day asking for the same, 3 mini-splits with no accessories and they wanted to pay with a credit card. I immediately remembered this thread and told them c.o.d for the units...
Has anyone been using their phone to take credit card payments? If so how do you like using them? Thanks.
I recently picked up the Appion and it works really well, the oil changes was the deciding factor on purchasing it. Compared to my yellow jacket pump it beats it hands down!
Thanks guys! Bad board!
My furnace's fan constantly runs and can't be turned off at the t-stat, it is interlocked with a bath fan. I checked all the wiring and it seems the only way to keep it from coming on is to...
If your licensed and ticketed or even a fourth year apprentice that is really low! A first year in this area usually starts out at 18-20 $/hr. When I started out on the east coast as a first year...
water runs uphill all the time
check out www.letcar.ca
There's usually a lot of openings in Northern Alberta. Pay is way above average and lots of work !