Search:

Type: Posts; User: tescontrols

Search: Search took 0.01 seconds.

  1. Replies
    13
    Views
    3,493

    Nuanla: Tracer Summit ver 17 is up to service...

    Nuanla:

    Tracer Summit ver 17 is up to service pack 10 which carries images up to 17.073
    You should be able to locate the latest service pack on the trane controls website.
    This will allow you to...
  2. Replies
    3
    Views
    653

    I believe the path I told you about was not...

    I believe the path I told you about was not correct.
    In setup you have to aim towards the cassette tape menu and use the system expansion menu to upgrade your schedule numbers or anything else for...
  3. Replies
    3
    Views
    653

    Its been awhile but here goes. In its initial...

    Its been awhile but here goes.
    In its initial set-up.
    You had to tell the software how many objects are in the system. For example if you new that you only needed 3 schedules then you would tell...
  4. Have you checked your back up database folder for...

    Have you checked your back up database folder for previous back up that task manager may have done?
  5. Replies
    1
    Views
    245

    Have you tested the signal without wires...

    Have you tested the signal without wires connected?
    What are you trying to control on the chiller?
  6. Replies
    2
    Views
    567

    I am assuming that you downloaded a saved...

    I am assuming that you downloaded a saved program.
    Make sure that your mp580 is a version 2 or greater. I know the version 1 mp580's would not accept expansion modules.
  7. Replies
    12
    Views
    1,719

    No Problem

    No Problem
  8. Replies
    12
    Views
    1,719

    you are correct. It is v7.1 I have an upgrade...

    you are correct. It is v7.1
    I have an upgrade disk.
    Not sure who is looking for it though.
    puniverse or vathicus
  9. Replies
    1
    Views
    527

    You are correct in assuming that the comm wire is...

    You are correct in assuming that the comm wire is good.
    It also looks like you do have at least Summit software since you were able to identify the device. You might want to check in your tools tab...
  10. Replies
    12
    Views
    1,719

    I can make a copy of mine and send it to you....

    I can make a copy of mine and send it to you.
    Not sure if you need v6 or v7.
  11. Replies
    5
    Views
    1,406

    Energydobashi. I was wondering how your...

    Energydobashi.
    I was wondering how your training was going. I have been using Tracer since it was a dos program and have been to many classes as well as taught several classes.
    The classes you...
Results 1 to 11 of 11
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event