Search:

Type: Posts; User: klyons20

Page 1 of 13 1 2 3 4

Search: Search took 0.02 seconds.

  1. Thread: houston area

    by klyons20
    Replies
    3
    Views
    331

    houston area

    iam visiting from Detroit I need a 20kw heat for a a goodman61-10 unit. and a spw-01.
    I don't think my Michigan license will work. at johnstone

    regards,
    Kelvin
  2. Replies
    19
    Views
    1,736

    sound like draft motor to me

    sound like draft motor to me
  3. Replies
    4
    Views
    1,199

    check voltage coming to furnace if les than 110...

    check voltage coming to furnace if les than 110 volts then switch breaker to other leg. Put breaker on highest voltage leg in breaker box. and are replace wire to spark probe (make sure has a good...
  4. Carrier / Bryant Draft Inducer Motor 318984753, 318984-753

    I have 10 year old furnace flame floats a litte going into heat exchanger. cycles out on flame senor..
    When i remove vent pipe flame flow normal.. Iam thinking new draft motor.
  5. Replies
    40
    Views
    12,614

    There are suggested books that you can read for...

    There are suggested books that you can read for the test... You need to know code to pass.
  6. Replies
    5
    Views
    4,695

    Super-Freeze 22a Refrigerant

    Super-Freeze 22a Refrigerant - R22 Freon Drop-in Replacement - 30 lb Equivalent

    Anyone using the Super-Freeze 22a Refrigerant ?

    What you take on it?

    Any cons?


    regards,
  7. Replies
    6
    Views
    1,188

    Pull fan motors and clean secondary heat coil...

    Pull fan motors and clean secondary heat coil just above the fan! Use a coil cleaner.
    This could be your problem
  8. Replies
    1
    Views
    756

    whirlpool gd5shaxlq02 ice maker

    whirlpool gd5shaxlq02 ice make stop working..

    the arms on the ice maker seem to be normally position.

    There is a wiring harness that connects the ice make black white green brown. How do i...
  9. fan limit switch vs a fan control board

    A fan is controlled by two ways a temperature switch or a fan board
    The fan board will run regardless of the temp.

    fan limit switch
    The temperature switch will open and close the switch based...
  10. I work on a loading dock we use around 150k btu...

    I work on a loading dock we use around 150k btu to 250k btu per door.

    They run 24 hours. There no match agaist and open door.
  11. This is normal behavior is you are using a...

    This is normal behavior is you are using a combination fan limit controll.

    If you want a unit to catch up fast then put a bigger unit in or more units.
  12. Replies
    15
    Views
    996

    u need some one in your area.. Call and get...

    u need some one in your area.. Call and get prices to replace..
  13. Replies
    40
    Views
    12,614

    Heating and Cooling Essentials

    Heating and Cooling Essentials (Hardcover)
    by Jerry Killinger
    Jerry Killinger (Author)
    Visit Amazon's Jerry Killinger Page
    Find all the books, read about the author, and more.
    See search...
  14. Replies
    40
    Views
    12,614

    Buy book heating and cooling essectians by...

    Buy book heating and cooling essectians by ladoona read heating section
  15. Replies
    16
    Views
    24,517

    use less energy

    [QUOTE=rChris;1511988]Not looking like Rheem makes a VS furney, just a 2 stage that has a ECM motor.

    So if that's the case, could someone esplain what's so great about these motors. Looked at the...
  16. dirty coil

    A dirty filter can not cause a coil to leak. These new puron system are under a lot more preasure than r-22. So if everything is not done perfectly in the installation you will get leak down the...
  17. Replies
    21
    Views
    5,382

    make sure control voltage is constant

    Make sure control voltage is present to determine if contactor is not working.
    I feel like something in the circut is opening up.
  18. Replies
    4
    Views
    613

    Quiet Running Ac Unit

    Who makes the quiet running Ac Condener R-22.
    I had a magazine that show all the unit and the decimal rating.
    Iam replacing a condenser and the costumer insist on a quiet running system.
    I will...
  19. This calls are a pain in the behind. You have to...

    This calls are a pain in the behind. You have to pump down the system put an 160 psi of nitrogen and do a buble test. Close the valves and come back the next day to see what side is leaking the a...
  20. Replies
    16
    Views
    1,399

    mechanical code book

    Normally the BW vent change to B vent once it enters the attic. So you would use the same code that applies to b vent. Slop of the rood decides how tall the vent pipe should be. As long as this is...
  21. Replies
    14
    Views
    1,343

    ok

    set t stat to lowest setting . you only want to keep it above freezing.


    regards,
    Kelvin
  22. hello

    Piece where are you from?
  23. Replies
    2
    Views
    1,112

    Are they any beginners that need a little on the...

    Are they any beginners that need a little on the Job Training? You will provide the free help. I will provide you the experience.

    Regards,
    Kelvin Lyons
  24. Replies
    11
    Views
    1,122

    dont do it

    Dont waste you time .. These units will not fit most applications..

    regards,
    K
  25. Replies
    2
    Views
    644

    Why do the good man sound like a cannon ball when...

    Why do the good man sound like a cannon ball when starting.
    I need a quiet furnace for a job installation in the attic above the bed room. I am on a tight buget.

    Goodman product or comfort air...
  26. Replies
    16
    Views
    1,665

    Call a tech

    We give advice! I can not tell you how to fix that problem, plus it could be so many things until if you dont have a volt test you can not fix it.

    regards,
    K
  27. Replies
    3
    Views
    630

    ED25TEXHW01 REFRIGERATOR WHIRLPOOL Model of...

    ED25TEXHW01 REFRIGERATOR WHIRLPOOL

    Model of my whirlpool
    THERMOSTAT ASSEMBLY 2198202

    I have whirlpool that I am having problems with.
    The coil freezes up over time and cause the unit to run...
  28. Replies
    26
    Views
    3,516

    hi fire furnace

    It depends on how the dual stage is setup . Robo.
    The little jumper on the board and weather you have a two stage t-stat.

    Now explain to me how the furnace will know to go into hi fi mode after...
  29. t-stat

    I have a thermastat that has that feature. I can tell it 10 min every hour are all the time. the t-stat cost me 100.

    the one thats made by invensys i think.

    regards,
    Kelvin

    [Edited by...
  30. Replies
    24
    Views
    2,228

    system

    The people in texas specailize in installing systems in attics. Also, a well ventilated attic is a good. R-30 on the floor of the attic.

    regards,
    Kelvin
  31. Replies
    26
    Views
    3,516

    I would prefer

    I would prefer a dual stage varible speed motor but it depends on how much money do u have. Is a dual furnace is better of course. But a single stage will do..

    regards,

    Kelvin.
  32. Replies
    34
    Views
    5,250

    secondary drain

    What I am saying is is that you need to use both the primary and secondary drain in the attic. The drain pan can be you last resort with cut offs.

    regards,
    kelvin
  33. Replies
    34
    Views
    5,250

    Very good looking job

    I was wondering how you made money on this job.

    Do you have a secondary drain installed in case the first one becomes clogged up for some reason.

    The drain pan under the furance should be...
  34. Replies
    34
    Views
    5,250

    Very good looking job

    I was wondering how you made money on this job.

    Do you have a secondary drain installed in case the first one becomes clogged up for some reason.

    The drain pan under the furance should be...
  35. Replies
    16
    Views
    2,363

    Wrong 90 degree ell being used

    First of all you contractor is not using the right type of 90's. He should be using long 90 degree elbows. He needs to add an extention to the pipe and take it up about 3 feet.
    I need to check with...
  36. Replies
    2
    Views
    573

    why would I do that

    When i have you guys. Everything around here get fixed by me. All I need is a little direction.

    regards,
    Kelvin
  37. Replies
    2
    Views
    573

    ED22TWXDN01 REFRIGERATOR WHIRLPOOL I can her...

    ED22TWXDN01 REFRIGERATOR WHIRLPOOL

    I can her fan running but unit will not start and get cold tried to turn timmer, reset cold control, but unit tries but want start. I hear the clicking like it...
  38. Replies
    11
    Views
    1,075

    ac

    If there is nothing wrong with ac then dont mess with it.
    Just make sure the contrator clean A-coil while he replaing unit.

    regards,
    Kelvin
  39. Replies
    78
    Views
    6,330

    oversize furnace

    If the size of the furnace did not make a difference then one furnace fits all. An over size furnace short cycles this leads to more break down. Over size furnace cause high limit to make more often,...
  40. ventilaion

    Vern, I dont have time to look it up .. Goto chapter that say ventilation (mechanical code 2003). Thats one of the first things you will learn is that ventilation is no required when there is not one...
  41. make up and ventilation air

    We are talking about ventilation and make up air. Not what comming out of vent.

    regards,
    Kelvin
  42. drop a 4 inch hole

    A 4 inch hole will do for the size your house.

    regards,
    kelvin
  43. Replies
    112
    Views
    21,048

    ventilation

    If the space in not properly ventilated.. Then it would be right for mold.

    regads,
    Kelvin
  44. call a contractor

    If you have that 6 in pipe comming in from the out side near the furnace then you are ok for combustion air.

    If you are going to have a furnace room then install vent grills to basement side. One...
  45. Replies
    112
    Views
    21,048

    it depends

    It depends where you are installing. example attic, basement, under the house, outside. If you are in the attic then you need insulated duct. Flex would be a better deal.

    regards,

    Kelvin Lyons...
  46. Replies
    17
    Views
    18,790

    all day

    It s to many varibles to say. It could run all day just to keep up.

    regards,
    Kelvin
  47. Thread: New Furnace

    by klyons20
    Replies
    6
    Views
    743

    hey

    You need a heater that vents to the outside.
    WE dont do prices here!

    regards

    Kelvin
  48. vern p

    I'm hearing that all the classifacations for mechanical are going to be combined. Sort of like a master plumber.
    And if you have at least half under your belt you will be grandfathered in.

    A...
  49. book

    Look up a book called heating and cooling essentials.
    Its red and blue in color. read everything related to heat in that book and I think you will pass.

    regards,
    Kelvin
  50. Replies
    13
    Views
    1,535

    just my opinion

    insulation is allways good.. but sizing a furnace for a house. takes a lot of things under consideration. Its called a load calculaiton Manual J. You are better off with a furnace too small than to...
Results 1 to 50 of 647
Page 1 of 13 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event