Search:

Type: Posts; User: Steve Wiggins

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Permit question: Pulling extra circuit for a/c

    I installed a new a/c system from scratch to handle an enclosed garage plus a couple other rooms and I need an electrician to pull a couple circuits to my equipment. Sparky is telling me that since...
  2. Replies
    2
    Views
    793

    I'm asking because I want the damper to open in...

    I'm asking because I want the damper to open in the cool mode only and this is a heat pump. So I ran a wire from the "O" terminal on the stat to the "PO" terminal on the damper motor... I would like...
  3. Replies
    2
    Views
    793

    EWC Damper motor wiring

    On my EWC damper motor I have three terminals: COM, PO, PC. (Common, Power Open, Power Close) What would happen if PO and PC had power on them at the same time? Would it burn up my motor?
  4. Replies
    4
    Views
    876

    RedLINK?

    RedLINK?
  5. Replies
    4
    Views
    876

    Simple restaurant controls

    I'm looking to recommend a control solution for a local restaurant I do the environmental a/c work for... Currently there are 6 RTU's (gas packs) and all have stand alone stats. They want all the...
  6. Replies
    6
    Views
    775

    Bigger is definately better!

    Match ductwork with equipment and oversize the heck out of it...IMO. Just blast em with cold air ...pay no attention to all those "won't run long enough to remove moisture" men behind the curtain.
  7. Replies
    47
    Views
    4,765

    Every outdoor unit says Max fuse size, NO resi...

    Every outdoor unit says Max fuse size, NO resi equipment ever has fuses, only breakers.. So basically all the equipment in my area is installed incorrectly?
  8. Replies
    14
    Views
    1,657

    It depends on the symptoms. If the problem was a...

    It depends on the symptoms. If the problem was a bad contactor and the compressor run cap was leaking I would give the customer the option priced in writing. If the symptom was compressor won't...
  9. Replies
    7
    Views
    1,223

    Heat element stuck on

    Heat element stuck on
  10. Replies
    5
    Views
    856

    Every pan does this to me and other techs say the...

    Every pan does this to me and other techs say the same thing so I don't need to hear from any Goodman reps that claim they never heard of this problem...please, thank you.
  11. Replies
    5
    Views
    856

    Condensate overflow - floor damage

    I'll pay for the floor damage because,,,yep it's may fault...BUT:

    The Goodman condensate pan on the upflow AHU is warped so when you screw in the drain fitting it causes the drain to run uphill. ...
  12. Replies
    1
    Views
    720

    Vapor barrier seal on flex duct

    I remember reading somewhere that the proper method on sealing flex duct vapor barrier is to tuck the silver foil under and zip tie...

    I realize you can also seal it with approved tapes & mastic...
  13. Replies
    1
    Views
    390

    clearance to wall mount heater

    What are the rules regarding installing an outdoor condensing unit in front of a wall mounted water heater? I'm not going to be directly in front of the water heater but pretty close...
  14. Replies
    2
    Views
    523

    Lennox Evap Model Number...

    According to Lennox literature an indoor evap C14-41-1FF is a "3 ton". Buy my question is what does the 41 mean? 41,000 btus?
  15. Replies
    48
    Views
    17,157

    Why would you want clean ducts?

    Why would you want clean ducts?
  16. You guys with all that basement area around...

    You guys with all that basement area around equipment are spoiled.
  17. Replies
    3
    Views
    729

    Trane Wreck

    http://sphotos.xx.fbcdn.net/hphotos-ash4/402015_3265063595927_1547375903_32901688_649700035_n.jpg
  18. Sneek up behind him with a zip tie slip it over...

    Sneek up behind him with a zip tie slip it over his head and CINCH! No blood, no mess.
  19. If you have been in school you have already...

    If you have been in school you have already wasted a lot of time. Get out there and get your feet wet! Work in some non profit areas like colleges & school districts to be exposed to many different...
  20. Are the Control4 stats getting power from a...

    Are the Control4 stats getting power from a common wire or battery? Is the stat set to disable power stealing?
  21. Replies
    13
    Views
    1,734

    Andr, your brain understands the written word...

    Andr, your brain understands the written word well obv, but that is not always the best way for others to interpret material. Your mom prolly played chutes & ladders with you while their moms were...
  22. Work for a college or school district changing...

    Work for a college or school district changing air filters. This is where you will learn how to compensate your low wages by stealing all the tools & refrigerant you will need to start your own...
  23. Replies
    1
    Views
    355

    conveyer belt manuf

    Need help identifying the manuf of a conveyer belt system...name plate has been removed.
  24. Replies
    17
    Views
    1,268

    My attorney told me, "you big dummy you're not...

    My attorney told me, "you big dummy you're not good at writing collection letters, let me write the letters from now on"...

    Just come out and tell the guy....
  25. Replies
    17
    Views
    1,268

    Snapperhead that's a horrible way to treat a...

    Snapperhead that's a horrible way to treat a customer...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event