Search:

Type: Posts; User: Louie13

Search: Search took 0.00 seconds.

  1. Replies
    42
    Views
    4,893

    Over tensioning can cause problems as well. You...

    Over tensioning can cause problems as well. You really want to hit the exact tension for your drive based off of the specific HP, RPM, sheave sizes, etc.

    Continuing problems could be due to too...
  2. Replies
    33
    Views
    2,114

    Well I work for a belt company and what everyone...

    Well I work for a belt company and what everyone said is correct.

    You should reduce the center distance by loosening the motor, put the belts on, and then increase the center distance until you...
  3. Thread: Matched Belts

    by Louie13
    Replies
    16
    Views
    2,151

    Matched Belts

    The RMA (Rubber Manufacturers of America) tolerance for a 5V1000 V-belt is:
    +/- 15mm (0.591 inches)

    A set tolerance is +/- 6mm (0.236 inches)

    All belts from any manufacturer must meet the...
  4. Replies
    10
    Views
    2,280

    Optibelt

    Hey ya'll,

    A bit more information on the Optibelt HVAC product from an Optibelt engineer.

    The belts have a special cord and fabric wrap that makes the belts very flexible so they can bend...
Results 1 to 4 of 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event