Search:

Type: Posts; User: bkirchner81

Search: Search took 0.00 seconds.

  1. thank you Mr. Bungalows. I will try that and...

    thank you Mr. Bungalows. I will try that and get back to you with more questions! haha.



    thanks again!
  2. STAEFA MS1800 multiple setpoint control?

    Say I have 4 VAV's heating a hallway. Can I create a math block or some type of point where I can adjust the temp setpoints of ALL FOUR VAV's with one point on the screen ?

    Thank guys (Jogas I...
  3. Replies
    9
    Views
    873

    wow, very good information from all of you...

    wow, very good information from all of you guys.


    thank you very much, this has been very helpful to us. :D



    HVAC-Talk is the schnizz....
  4. Replies
    9
    Views
    873

    hey I wanna thank you guys for helping me out. ...

    hey I wanna thank you guys for helping me out. Mucho Appreciado.

    We are still looking into several options, and we'll take any input from you guys.

    :)



    ben
  5. Replies
    9
    Views
    873

    TAC Micronet Pros/Cons?

    My company is looking to install controls in one of our maintained buildings.

    Can anyone provide me with some pros or cons of the invensys TAC Micronet BACnet system?

    We use Staefa MS1800 in...
  6. Replies
    3
    Views
    405

    ""• Digital—15 characters for the units value of...

    ""• Digital—15 characters for the units value of the current state (active or inactive).
    Note: If the “Hide Status” parameter on the System Manager User Setup screen is
    selected, this option hides...
  7. Replies
    3
    Views
    405

    MS1800 graphics

    hey fellas,

    when I install MS1800 on a new machine- the graphical display of all points in 'automatic' have an "AU" in front of the numbers. Everything in a manual state has "MN" in front, ...
  8. Replies
    10
    Views
    1,048

    It was not completely dead, no. The...

    It was not completely dead, no. The transformer itself? I believe it was fine also.

    It appears that all communication ports were lost- LAN, Serial, (the Ethernet port on this board was...
  9. Replies
    10
    Views
    1,048

    easy friends, im still here. Just a little...

    easy friends, im still here. Just a little busy.


    It was our Master "A" board. Appearently what caused the initial power outage was a lightning strike to the building. This was the...
  10. Replies
    10
    Views
    1,048

    Could be the Node is trying to dial out or...

    Could be the Node is trying to dial out or connect to a printer on the port you're on.
    At this point I have deleted the database- our modem was connected to host A but that should be irrelevant...
  11. Replies
    10
    Views
    1,048

    Are you sure you have the correct settings and...

    Are you sure you have the correct settings and port for a dirrect connection?
    yes sir

    Could be the Node is trying to dial out or connect to a printer on the port you're on. Check the dip switch...
  12. Replies
    10
    Views
    1,048

    Staefa Ncrs Emergency

    Hey guys,

    I work in a LARGE building with about 20 NCRS panels which are used to communicate between DDC boards and my controls computers.

    A power outage occurred Monday night and now I...
Results 1 to 12 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event