Search:

I have used these in the past for special applications (walk-out basements, commercial property to avoid zero turn lawn mowers). I also mount rubber isolators to the brace and bolt the condenser to...

I have been installing Fan Hnandler controls for 15 years with great success. I like how they operate a psc mtr. and the only reason I have not installed a ecm modulator is because the local and...

Brings a whole new meaning to "custom" ductwork!

They get a pretty good buck for those dollies but it is a serious consideration. Thanks

I am thinking about buying one (just herniated a disc). How do you like it? Does it have safties so you won't roll down the stairs too fast? Is it heavy? Tell me more.

Ok what is it?

You could also install a 2H/ 2C stat and a seperate control transformer and wire one 1st stage and the other 2nd stage. I have a system like this and I run continus blower on both to keep temps even.

That will certianly help speed up the trouble shooting when the customer calls complaining about noise lol.

I have found that by installing the restrictor in the intake improves combustion quite a bit. The manual says to install the restrictor on vent that is 10' or less, on all 40k furnaces some 100k...

:cheers:When we can all agree on something maybe we should see about a large volume discount.

So if you follow the manual your good to go and if you follow the manual and check w/ CA and your oxygen is 12% at least you checked? I used to do it the same way before I bought my CA and knowing...

The first stage isn't typically the most efficient way to heat the house. I'm not saying you can"t fine tune first stage but from what I have seen second stage is more efficient.

I have a TESTO 327 w/ printer and it was $1200 new.

The only way to know for sure is with a combustion analyzer. If you don't own one ask someone you work with to come over and verify the combustion.

Although I like the idea....light, insulated, smooth surface that won't come apart in air stream.

I think it's home made because you can not have exposed foam in any installation that I am aware of. The reason is it's highly toxic when it burns so it always has to be covered.

A digital meter is great but I double check my measurements w/ a U-Tube manometer to ensure accuracy. U-Tube never needs batteries or calibration.

DO you have a Battries Plus store near you? I had my Dewalt battries rebuilt w/ larger capacity cells for less $ than buying new ones.

This is a special situation where my mother ownes an appartment building so if I tell them the furnace needs repair they will authorize the repair. I have two new HX on the truck but have not been...

I was doing 2 c&c on 2 furnaces a couple of weeks ago, both goodman furnaces. I found cracked hx on both furnaces (visual) so I fired up my 327 to see how they were operating. Furnace #1 had rising...

Are there lay out instructions on the box for this? That's special

The way the motor knows how to adjust speed is done electronically. The motor communicates the RPM to the board and the board inturpets this for CFM. If the motor still ramps up and down I would...

I haven't had any of these issues yet...but I will be on the look out for the float issues. I used to use Little Giant pumps but I have replaced them all with Diversitech because of mirco switch...

Sorry kdean I was a little slow on that lead in.....Yes I drove 8.5 hrs for the class and It was well worth it! Very enlighting.

I just purchased the YJ eccentric and I am very happy with it. I was using a malco "roto flare" and it would split or deform the tubing. It sounds like the YJ is probably the same as the ridgid, so...