Search:

Type: Posts; User: iez44

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    1,779

    you were correct, the igniter was bad. very...

    you were correct, the igniter was bad. very expensive imho, but very easy to change. btw, the new igniter measured 37 ohms resistance.

    thanks for your help.
  2. Replies
    2
    Views
    1,779

    Quadra Fire Mt Vernon AE Igniter Question

    Can anyone tell me the correct resistance value of the igniter? I measure an open circuit on mine, which I believe is the problem with mine not firing. I get no screen errors on the wall control...
  3. I have an AE and was having a similar problem...

    I have an AE and was having a similar problem where mine was saying auger jammed. , I don't know if yours is built like mine; however, here's a simple explanation of what I did. Pull out the...
  4. Thanks for the advice. I'll check the wiring and...

    Thanks for the advice. I'll check the wiring and if I don't find anything, I'll contact my dealer on Monday.
  5. I know I'm going to have to replace something, so...

    I know I'm going to have to replace something, so which is it, the wall control unit or the control board in the stove? ....or maybe both?
  6. The QF Mt Vernon has an electronic wall control...

    The QF Mt Vernon has an electronic wall control unit that controls everything related to the stove. There are no controls on the stove itself.

    It has an LCD display that lights up blue when any...
  7. Flashing Wall Control Unit - QuadraFire Mt. Vernon

    The wall control unit of my Mt. Vernon has been acting up intermittently. Sometimes, adjusting the temperature causes the screen to go blank and flash - light up and get dark. It's totally random...
  8. i'm not sure what i did to correct the snap disc...

    i'm not sure what i did to correct the snap disc issue, but since the stove is running normally, i'll leave that for another day to figure out. as they say, "if it ain't broke..."

    thanks again...
  9. the results are in - the stove is working!!! ...

    the results are in - the stove is working!!!

    here are the details....

    1) i removed the auger assy from the stove and then removed the optical sensor from the assy. i cleaned the sensor and...
  10. bw & jtp- thanks for the fix tips. i will try...

    bw & jtp-

    thanks for the fix tips. i will try them this morning after i get back from church service. is there anything special i should use to clean the wheel & sensor? dry cloth? water? ...
  11. burning wood, thanks for the suggestions. ...

    burning wood,

    thanks for the suggestions. looked at everything; however, nothing worked.

    there is an optical switch on a wheel that is located between the auger shaft and the auger motor. ...
  12. Quadrafire Mt Vernon Troubleshooting Help Needed

    I have a 3 yr old Quadrafire Mt Vernon that has worked flawlessly until recently. For the last week or so, I had been getting an intermittent "auger jammed" error message. Each time I could reset...
Results 1 to 12 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event