Search:

Type: Posts; User: ironman597

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    1,022

    This is the Ask Our Pro's forum, and only Pro...

    This is the Ask Our Pro's forum, and only Pro members that have been vetted by the AOPC may post advise, commentary, or ask questions of the OP here.

    You can find the rules for posting and...
  2. Replies
    8
    Views
    1,207

    I agree with softtail - Use the mechanical...

    I agree with softtail - Use the mechanical unloading plate and dial in. These compressors with the mechanical unloading work great and trouble free.
  3. Replies
    15
    Views
    1,203

    Tomjung I made a bad assumption earlier that...

    Tomjung

    I made a bad assumption earlier that you were just a very green service tech who had some strange readings.

    I strongly recommend you contact a qualified service technician to provide...
  4. Replies
    7
    Views
    376

    Without seeing the job site and conditions,...

    Without seeing the job site and conditions, structure of the house and difficulty factor of the project, also warranty dollars are figured in and when you have a problem and call they need to make...
  5. Replies
    15
    Views
    1,203

    control voltage assumed to be 24 V at coil and...

    control voltage assumed to be 24 V at coil and contactor energized voltage assumed to be correct at 230v 1 phase , then contacts on contactor would be bad. Again assumption is above conditions are...
  6. Replies
    3
    Views
    808

    If this is a primary secondary with variable flow...

    If this is a primary secondary with variable flow to different zones, this is potentially a nightmare. I had one it took me 8 weeks and countless hours to finally figure out the original design and...
  7. Replies
    5
    Views
    673

    If you use a curb adapter make sure you check...

    If you use a curb adapter make sure you check level and orientation of existing unit for drain. Quite frequently original curbs are not installed perfectly level and then a curb adapter is used and...
  8. Replies
    4
    Views
    677

    Dan Holohan has a great book " Deadmen" it is...

    Dan Holohan has a great book " Deadmen" it is about steam piping systems. One thing about steam. Put it back the way you found it. Typically it has been working years . DO NOT rengineer it. You can...
  9. Replies
    3
    Views
    1,625

    humidity

    After reading your post you do not mention what the temperatures are. Also if humidity is critical to you and the desire to maintain 40-45% humidity then your systems are all wrong. Going after...
  10. Thread: fan cycling

    by ironman597
    Replies
    21
    Views
    1,651

    I agree with chillermech. The p66 is the way to...

    I agree with chillermech. The p66 is the way to go. ICM does have setting for ball and sleeve bearings but with a sleeve bearing motor the motor needs to run at 40% speed to lubricate the bearings....
Results 1 to 10 of 16
Comfortech Show Promo Image