Search:

Type: Posts; User: Brad1980

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    703

    I was 19 when I started as a helper. I worked my...

    I was 19 when I started as a helper. I worked my way up to service manager when I was 25.
  2. Replies
    6
    Views
    1,104

    If the motor should be running and its not, use a...

    If the motor should be running and its not, use a multi meter to see if you have 24V between G & C. If you have 24V make sure you are getting the proper voltage to the motor (120V, 240V depending on...
  3. Replies
    34
    Views
    3,717

    I agree 100%. Pressure alone means nothing. That...

    I agree 100%. Pressure alone means nothing. That being said, with the information that is here I don't think its a stretch to figure out what the SH is. That pressure converts to around 16 degrees...
  4. Replies
    34
    Views
    3,717

    If the piston is in fact too small you would have...

    If the piston is in fact too small you would have high superheat and subcooling. Now I will keep in mind the fact that SH & SC have not been checked.... But the SH can't be very high if the suction...
  5. Replies
    34
    Views
    3,717

    The piston may or may not be the right size but...

    The piston may or may not be the right size but with that suction pressure (70psi) I think that coverts to somewhere around 16 degrees, along with the suction line freezing I would have guessed the...
  6. Replies
    34
    Views
    3,717

    Lennox tech support is pretty good. When I worked...

    Lennox tech support is pretty good. When I worked for a lennox dealer we used them often to order parts and get answers to problems. Provide them with model and serial numbers of the equipment and...
  7. Replies
    34
    Views
    3,717

    Did you mean you started with the 10lb factory...

    Did you mean you started with the 10lb factory charge that came in the condenser and added 8oz, or that you added 10lbs 8oz to the unit? I assume you just added 8oz.

    Could be low air flow.......
Results 1 to 7 of 8
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event