Search:

Type: Posts; User: docjones

Search: Search took 0.00 seconds.

  1. Replies
    13
    Views
    2,422

    Sounds like you have a Beacon II, probably with a...

    Sounds like you have a Beacon II, probably with a MAC condensor if you're at McDonald's. Best way to check the sensor is just put a thermometer next to it and compare the readings. Or 32,650 ohms @...
  2. Replies
    5
    Views
    712

    New solenoid, new sensor, new board, same...

    New solenoid, new sensor, new board, same problem?
    Check your ground. Specifically check your ground is good at DC connection, at line voltage connection behind machine and back to load center.
    ...
  3. Replies
    4
    Views
    1,087

    I just E-mailed you the info.

    I just E-mailed you the info.
  4. Replies
    4
    Views
    1,087

    I might be able to help you out. E-Mail me.

    I might be able to help you out. E-Mail me.
  5. Replies
    13
    Views
    1,204

    Assuming the float switch is good, if you're...

    Assuming the float switch is good, if you're getting a premature harvest the most likely cause is loss/lack of water in sump.
    A quick check- turn the machine off then back on. watch the drain line...
  6. Thread: Any ideas?

    by docjones
    Replies
    16
    Views
    994

    Schofield Barracks. I was the 65th Engineers...

    Schofield Barracks. I was the 65th Engineers years ago.
    Talk to the MWR office, they'll set you up with an electrician.
  7. Thread: Oil Trap?

    by docjones
    Replies
    16
    Views
    6,838

    http://hvacloads.com/talkpics/wall/11.jpg ...

    http://hvacloads.com/talkpics/wall/11.jpg


    This is actually something I run into fairly often. Line sets for an Ice machine condensor. How hard would it have been to cut the lines to length and...
  8. Thread: 9mm or not?

    by docjones
    Replies
    4,843
    Views
    301,431

    A 9 in time saves lives

    So you're in PA? After the military, I was a state trooper in Delaware. Now I do Refrigeration in Texas(It's always hot and the pay is great). I'm licensed and carry a .45 S&W with Federal PDP...
Results 1 to 8 of 10
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event