Search:

Type: Posts; User: BaldLoonie

Page 1 of 20 1 2 3 4

Search: Search took 0.22 seconds; generated 14 minute(s) ago.

  1. Both are good furnaces. We are a Rheem dealer and...

    Both are good furnaces. We are a Rheem dealer and also sell Allied, which is the Lennox furnace with a different board. The R96V with the Econet control is really slick if budget permits.

    Key is...
  2. York and ICP also have thin units but still are...

    York and ICP also have thin units but still are too thick for your specs.
  3. THX9421R5021WW That's the latest Prestige IAQ....

    THX9421R5021WW

    That's the latest Prestige IAQ. I'd go that route and make sure dehumidify on demand is hooked up. It will overcool like the 8321 but I don't like that. I'd rather have the DOD...
  4. Replies
    10
    Views
    250

    1-1 is a variable speed furnace with 16 SEER 2...

    1-1 is a variable speed furnace with 16 SEER 2 stage A/C. Nice system.

    1-2 is a 1 stage with constant torque high efficiency motor with basic 16 SEER 1 stage A/C. If priced quite a bit less than...
  5. Give us model #s.

    Give us model #s.
  6. Replies
    9
    Views
    280

    We found a Goodman that had a plugged internal...

    We found a Goodman that had a plugged internal drier that wasn't changed couple years ago. That well could be it on yours too. A tech needs to check things out. It may be cooling but sure isn't right.
  7. Replies
    9
    Views
    449

    Slasor was referred to me by 2 people to do my...

    Slasor was referred to me by 2 people to do my cousin's new house. Very impressive work.
  8. When I register an Allied (owned by Lennox) A/C...

    When I register an Allied (owned by Lennox) A/C and use a 3rd party coil (ADP, owned by Lennox) I can't do it online. I e-mail a lady at Allied and provide the model # and serial # of the unit and...
  9. Replies
    12
    Views
    369

    It isn't an 80% furnace. Just looking at the...

    It isn't an 80% furnace. Just looking at the output which is always 80% of input means that running non stop, you will get that much heat out of the furnace. What kills efficiency and makes it a 55%...
  10. The industry standard tends to be sizing the A/C...

    The industry standard tends to be sizing the A/C to handle 75 in on the hottest day of the year. So in my view, I wouldn't be happy with 83 inside.
  11. Replies
    51
    Views
    1,601

    Not much humidity out there but properly sized...

    Not much humidity out there but properly sized unit under extreme conditions isn't going to drop the temp much. On an super hot day, the fact you dropped 4 degrees in 2.25 hours says oversized!
  12. That antique was not meant to be installed...

    That antique was not meant to be installed horizontal!
  13. I can give you a list of the Trane units affected...

    I can give you a list of the Trane units affected by the TXV goo! It's in their latest service bulletin.

    It will be worse with Rheem as they are 100% Copeland scroll. Trane uses their recip and...
  14. Old as that is, probably a recip. Later Fedders...

    Old as that is, probably a recip. Later Fedders units used a rotary. Worked OK in A/Cs but sure didn't in heat pumps :D

    Yea I miss aircooled.
  15. I doubt you'll be able to register the Lennox for...

    I doubt you'll be able to register the Lennox for 10 year parts without a Lennox indoor unit but I could be wrong. Not sure about Carrier, never dealt with them on registered warranties.
  16. Back in the early 70s, Rheem made a little cube...

    Back in the early 70s, Rheem made a little cube A/C that sucked in the top and blew down into the unit. Never seen one since unless the blades were wrong or the capacitor was shorted causing the...
  17. Replies
    12
    Views
    369

    60s?

    60s?
  18. Replies
    9
    Views
    449

    http://www.slasorheating.com/

    http://www.slasorheating.com/
  19. Replies
    1
    Views
    115

    There is low ambient for cooling below about 60...

    There is low ambient for cooling below about 60 and now some heat pump makers are suggesting a mild ambient control for heating above 50 some. We especially ran into a problem with high head...
  20. Replies
    2
    Views
    260

    Good idea. Newer units could require more outlets...

    Good idea. Newer units could require more outlets to work properly. Check with them to see if there is anything you need to know before you quote and run into a problem!
  21. Replies
    9
    Views
    449

    That's a BIG furnace for 1800 sq ft. How did he...

    That's a BIG furnace for 1800 sq ft. How did he decide on size? That furnace will want to move near 1500+ CFM which can be loud if your duct system can't handle it and I highly doubt it can.
  22. Replies
    6
    Views
    417

    I have a late friend who used ceiling tiles,...

    I have a late friend who used ceiling tiles, barely hear a hum.
  23. Model # of the old unit might tell us if a curb...

    Model # of the old unit might tell us if a curb adapter is needed. You can take pictures of the job too.

    Most units with economizers just want a 2 stage thermostat. Focus Pro WiFi or Vision Pro...
  24. Hundreds of techs coming, clean the filters

    The Nashville Renaissance hotel, HQ for the recently ended Comfortech show. You'd think with hundreds of techs and other HVAC people coming, they'd clean the filters in their fan coils. Someone will...
  25. My avatar says your architect is a maroon!...

    My avatar says your architect is a maroon! Somehow separating the returns would be best. Or wiring the blowers to run 24/7 is pretty easy but will bump up the juice bill. A lot of times when a unit...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event