Type: Posts; User: John Culpepper
Probably a brother-in-law job. He can fix anything.:whistle:
If it has the Reliatel controls just jump it out. If the older controls, short out the "test" screws on the low voltage strip. Short them for a few seconds to walk the unit through the stages. If I...
Used to take the kids there about fifteen years ago. The food sucked, and the beer was flat. The kids had a good time though.
Have all of the 3 phase motors checked. I had a unit one time that needed both compressors and a blower motor replaced because of a squirrel on the transformer. The condenser fan motors were single...
I can see a restaurant owner hurting them selves.
A 15# 10 ton compressor.
Apply for Pro-membership. You won't be sorry. :)
I heard that enough when I was a kid and when I was grown. Would never touch the grand kids. They are my cuties. I think I have matured over the years. Would only give them positive advice.
20 years ago it was twelve Gs here. It all depends on your market and what you want to end up with as a career.
I was probably a bit too quick for spanking the kids when they were small. My father was more of an "enforcer" when I was a kid.
I kinda fell into the same role myself. One should wait to have kids...
I carry a Veto TP3, I'll get some pictures tomorrow. The TP3 and my Fieldpiece meter, I can at least have a problem diagnosed, if not fixed.
That is awesome.
I have been carrying that one in my bag for a couple of years now. Worth every penny.
Jumper the FCS and watch it. Is the unit 410a? I have replaced FCS with one of a lower psi rating.
If it has the fan cycle switches I would check those. I know I've replaced a few.
Will not glorify you...
Page three, sir.
Just so you know in the future, the things that will cause an iced evap coil is : lack of refrigerant flow(blocked evap coil, bad filters, crushed return duct) or lack of air through the system.
Try looking up aafame dot org. They have a job posting section.
If there is ice formed on your condenser then you either have a restriction in the airflow for the evaporator or refrigerant, Or you could be low on refrigerant.
Honestly, I got mine so people would leave me alone. Since tattoos have become more mainstream, people aren't as put off by them.( So people aren't leaving me alone):gah:
The best time to cut through Austin is between 7pm and 5am. Otherwise you're screwed.:whistle: