Search:

Type: Posts; User: shanemorton

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    10
    Views
    583

    mrkelly, Same thing here, the new secondary hx...

    mrkelly,

    Same thing here, the new secondary hx also had a gray housing and had that issue to. What do you normally do to fix that issue? I tried sanding down the stand offs. Anyway for those...
  2. Replies
    10
    Views
    583

    Rollout Trips

    A week ago I went to a customer house after the prev technician was out there due to rollout tripping, limit tripping. I went over there and I could that the rollout was tripping (tripped three times...
  3. Replies
    8
    Views
    523

    Replaced the RV today and the system works as a...

    Replaced the RV today and the system works as a charm.
  4. Replies
    1
    Views
    303

    Air Baffles?

    I been working on a older trane gas pack that acts up when I not there. Customer states that the unit would run for a few mins and go out and then it re lights the burners. I can't get it to do...
  5. Replies
    8
    Views
    523

    Not sure what IPR means? Compressor is pumping...

    Not sure what IPR means? Compressor is pumping because the pressures moves a little when shifting the RV and back to what it was before. I figure it was the RV that was bad in this case too and...
  6. Replies
    8
    Views
    523

    I did. RV Suction to Evap Coil = Cool RV...

    I did.

    RV Suction to Evap Coil = Cool
    RV Suction to Compressor = Hot
    RV Discharge = Hot
    RV To Cond Coil = Warm

    This seems to be in both Heat and Cool mode and I can hear the RV shifting a...
  7. Replies
    8
    Views
    523

    Dual Heat Pump / Gas Pack

    So, we been having some issues with this guy dual heat pump / gas package unit. I had changed the furnace board / hall effect sensor because of the resistor (R9) burned out and that fixed the...
  8. Replies
    10
    Views
    1,079

    Both SC76 & SC77

    Both SC76 & SC77
  9. Replies
    10
    Views
    1,079

    First time, the temp reading was stuck like OL or...

    First time, the temp reading was stuck like OL or -3254
    Second Time, kept beeping at random times as if you were checking high voltage, but the leads wasn't touching anything
    Third time, I can't...
  10. Replies
    10
    Views
    1,079

    Fieldpiece Meters

    Lately I have been upset with Fieldpiece meters, they do not hold up for anything. I had this meter as a replacement from another one that was under warranty that failed. I have already sent the...
  11. Replies
    4
    Views
    634

    Update: Turns out that the new module had...

    Update:

    Turns out that the new module had failed within a min of run time. Changed the module and the communicating board and working with no more issues.
  12. Replies
    4
    Views
    634

    Trane ECM Motors

    Ok, I don't normally ask too many questions.

    On Fri, I had a trane ECM/ICM blower motor failed. Went to the local supply house and got three things just in case. I got the module, motor, and the...
  13. Replies
    3
    Views
    462

    mrkelly, Thanks for your information, honestly...

    mrkelly,

    Thanks for your information, honestly I just learned something today. Didn't know that leaving the coil out of the post could do damage to the coil while voltage is on. I will check out...
  14. Replies
    3
    Views
    462

    Carrier GasPack

    No AC Call: Blank T-stat

    Get there, troubleshoot:

    5 Amp Fuse is ok
    Transformer is dead, had high voltage, no low voltage.
    Replaced Transformer and burned contactor.

    System ran great for...
  15. Actually I had a couple of them with frozen coil,...

    Actually I had a couple of them with frozen coil, added the stuff in the system and let it run for about 10 mins and had the turned off to thaw out the coil for about six hours and had the customer...
  16. Replies
    7
    Views
    913

    Like The_Sale said, scrolls do not like running a...

    Like The_Sale said, scrolls do not like running a low suction which causes the popping/hitting noise sometimes because the plates are hitting each other. Fix the leak and recharge the system.
  17. Replies
    56
    Views
    16,844

    Sir, You really need to listen to the people...

    Sir,

    You really need to listen to the people on this forums, go out and get your hands checked out. If you company is trying to force you back to work without getting checkout then quit and put...
  18. Replies
    14
    Views
    3,423

    Let me guess. Brand new install and located...

    Let me guess. Brand new install and located inside Lowes Hardware?
  19. Thread: Testo 510

    by shanemorton
    Replies
    0
    Views
    1,190

    Testo 510

    Would like to sell my Testo 510, going with Fieldpiece now. Comes with Box, case and a hose. Can send pictures. Make offer.
  20. Replies
    10
    Views
    1,381

    Oh, so it only happens with a single pole...

    Oh, so it only happens with a single pole contactor? Interesting
  21. Replies
    10
    Views
    1,381

    Trane HP (Strange)

    I am just wondering if anyone else find something like I did today. I went to a No Heat call, once I got to the customer home and talk to the lady. She said it was blowing out cold air out of the...
  22. Replies
    89
    Views
    12,879

    I be honest with you. This is something that...

    I be honest with you. This is something that don't make any sense, the main breaker for the panel is rated at a higher amp than the breaker for the AC unit. The breaker for the AC unit should had...
  23. Replies
    25
    Views
    3,936

    Then why A/H don't have them? What if the panel...

    Then why A/H don't have them? What if the panel falls off for some odd reason?
  24. Replies
    25
    Views
    3,936

    Sorry to hijack. But I always wonder why does...

    Sorry to hijack. But I always wonder why does the furnace have a door switch and not a A/H? What's it's real purpose?
  25. Replies
    14
    Views
    4,059

    I hate to say this, but that unit has never been...

    I hate to say this, but that unit has never been started up yet. The manuals are normally inside the burner area when it shipped from the factory. The best part is we leave them by the side of the...
  26. Replies
    56
    Views
    15,298

    I did this last winter when hooking up to my high...

    I did this last winter when hooking up to my high side on a older system that I never seen. It wouldn't stop pouring out of the value core where the gauge was connected to and I finally went in and...
  27. Thread: TXV

    by shanemorton
    Replies
    22
    Views
    3,956

    Thanks Gravity, I had flow in heat mode, but...

    Thanks Gravity,

    I had flow in heat mode, but was low. It was the TXV that was the issue, all fixed.
  28. Thread: TXV

    by shanemorton
    Replies
    22
    Views
    3,956

    oldguy1949, The low pressure switches on...

    oldguy1949,

    The low pressure switches on Carriers do open around 20 psi, I have seen them open around that pressure and like I said the suction had pulled into a vacuum which should had opened the...
  29. Thread: TXV

    by shanemorton
    Replies
    22
    Views
    3,956

    Like I said, this unit is four years old, so I...

    Like I said, this unit is four years old, so I don't think these are the same issues with the TXVs that we had last year and yes I had a couple of those too with the scroll compressor. I did not...
  30. Someone in my company used it to repair a inducer...

    Someone in my company used it to repair a inducer fan blower for a 90 percent furnace and it worked for about a year until it broke again. We ended up replacing the whole thing after that.
  31. Thread: TXV

    by shanemorton
    Replies
    22
    Views
    3,956

    TXV

    So I had a service call early this week about the OD unit being frozen. It's a Carrier HP split system and it's only four years old. The issue was that the whole OD unit was solid frozen, I had to...
  32. Replies
    15
    Views
    3,625

    jmsmars1, Don't feel bad, I went to a service...

    jmsmars1,

    Don't feel bad, I went to a service call on a Saturday. Told us they had a labor and part warranty. I drove 45 mins to get there and fixed the problem. Found out a week later that...
  33. Thread: Errrrr

    by shanemorton
    Replies
    27
    Views
    4,533

    Sorry guys, I should had taken some pictures. I...

    Sorry guys, I should had taken some pictures. I didn't because I was just sooo pissed off trying to change out a blower motor that had died because they didn't have any filters on that system. ...
  34. Replies
    0
    Views
    1,084

    Fieldpiece SC76 Issues

    Here my story:

    The support at Fieldpiece has been super great, but I have the SC76 meters. My older meter was still under warranty and the reading had just been floating around, even if you were...
  35. Thread: Errrrr

    by shanemorton
    Replies
    27
    Views
    4,533

    It's a Rtu Gas Pack, one with the furnace/ac in...

    It's a Rtu Gas Pack, one with the furnace/ac in one unit. I guess the roof will have to be taken apart to replace the system.
  36. Thread: Errrrr

    by shanemorton
    Replies
    27
    Views
    4,533

    Errrrr

    Ok, it been a day for me. I don't normally do commercial work, but why do people put a 4 ton gas pack in a attic with no way to walk around the unitr. I only had at least 1 feet clearance on the...
  37. Replies
    66
    Views
    12,492

    Normally we don't have any contact to the...

    Normally we don't have any contact to the customer, so the office makes the call for us to let them know that we are on our way. Seem that the office forgot to make that call that day. Most of the...
  38. Replies
    66
    Views
    12,492

    Oh I can list a couple that drives me up the...

    Oh I can list a couple that drives me up the wall.

    1: I drive like say 30 - 45 mins from home to a service call and the last min before I get there, the customer cancels. I had a couple of those...
  39. Replies
    1
    Views
    691

    Testo 317-3 Issues

    I went out to a call to inspect the HX and took the unit apart. Inpected the HX and it was in a great shape. I decided to get my Testo 317 out and place it on top of a vent near the GPACK. Talking...
  40. Replies
    21
    Views
    4,024

    I will agree one thing that ikapigian said. You...

    I will agree one thing that ikapigian said. You about to injury yourself, to me you didn't connect this correctly and yes it needs to be in series.
  41. Replies
    21
    Views
    2,806

    The problem is that these units does not come...

    The problem is that these units does not come with anti frosting stat on them when these unit was installed last year. These unit are still under warranty from Goodman and the apartment company...
  42. Replies
    21
    Views
    2,806

    Went back out there again with two more unit...

    Went back out there again with two more unit frozen, did found the ah in the clubhouse high voltage wired in the wrong breakers cause it too trip when the heat strips came on. Maintenance guy thinks...
  43. Replies
    21
    Views
    2,806

    No telling, they not going to spend money to...

    No telling, they not going to spend money to install fan controls, there are 100s of these units and they are warranty for a year. Not saying it was in the 60s when they frozen. Lately our od Temps...
  44. Replies
    21
    Views
    2,806

    It's all good, I figure you misunderstood a...

    It's all good, I figure you misunderstood a little, maybe I word it wrong, should had said cool mode and not AC.
  45. Replies
    21
    Views
    2,806

    Re-read what I just said. It runs fine in heat...

    Re-read what I just said. It runs fine in heat mode, they are running in cool mode when it cold od.
  46. Replies
    21
    Views
    2,806

    Goodmans Evap Coil Freezes

    I keep going to a apartment complex that has Goodman AH & HPs. For some reason their tenants keeps running their ACs when outdoor temps are cold, like in the 40 - 60 degrees. I not even sure how...
  47. Thread: Tstat wire

    by shanemorton
    Replies
    8
    Views
    1,255

    The non-insulation kind works best.

    The non-insulation kind works best.
  48. Replies
    2
    Views
    837

    We had a couple that went bad with E1 the next...

    We had a couple that went bad with E1 the next day after installing them. We just replace the t-stat face, not the brain. There something in the face that just goes bad, who knows what.
  49. Replies
    12
    Views
    2,529

    Who did the install? Someone at your company? ...

    Who did the install? Someone at your company? Now I suppose your customer wants you to clean that black crap off...
  50. Replies
    12
    Views
    3,016

    Is this a brand new system, if so it needs to be...

    Is this a brand new system, if so it needs to be replace again who ever installed this system. No customer should get a new system that is full of soot. Last year, we made this same mistake and we...
Results 1 to 50 of 97
Page 1 of 2 1 2

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365