Search:

wrong, trane is not partners with american standard. hasnt been for about 3 years now

nor is he in compliance with EPA for not keeping refrigerant records. just sayin...

depending on wire and if its comm 5 he would read 40-75ohms, closer to 0 is open ie: no EOL resistors or cut/damaged wire

thats true but he didnt say so i only assume. And i have a 11 yr old site thats comm 5, i think he mention 5 yrs old on his.

To the OP, right click on a graphic and click edit, in the setup tab...

I agree with mallron, most mechanical/electrical installers trash or misplace the cd's. And if you would have not offended Trane employees on this site b/c your being a bad a$$ behind a keyboard I...

do they have a NID assigned to them?

you will need to get a upcm cable and a cpu with BCU IP config to upload the ip settings in the BCU, and as far as the units your not talking to. they could have been powered off for a prolonged...

thanks email sent, yes i use rover configed for Lon4

thanks for the help but im still a bit lost where do i go from here?

http://i160.photobucket.com/albums/t188/adamrich33/NodeUtil.jpg

this is a well explained answer, follow his advice. the above reply was a bit vague and useless.

if you are reffering to a vfd, the transducer gives the controller a static reading to which the vfd/controller will ramp up and down at a given setpoint. typical transducers give a output dc voltage...

got a serial?

isnt that setpoint adjusted at the module on the unit

try a database and clear,ram reset.

oh, the site i was referring to is running 3.4.43, might want to give niagara a call.

what nodeutil version do you have, mine will try to run but as soon as it opens it will close down.

Anyone have windows 7 running node util via echelon usb adaptor?
i have also lost my function of hyper terminal.

ive seen it with LCIRs before, like you said, delete and rediscover always resolves that. Not sure what the deal is, however i have seen tridium panels installed with a termination module on the...