Search:

Type: Posts; User: Tempted

Page 1 of 19 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    58
    Views
    7,986

    I grew up on fieldpiece and like the accessories....

    I grew up on fieldpiece and like the accessories. I bought a fluke and have it for a spare. I have had issues with my fieldpieces mainly in the temp areas but then I dont treat them like I should...
  2. Replies
    122
    Views
    9,563

    Tostaky, Do what the tech that is working on it...

    Tostaky, Do what the tech that is working on it told you to do!!! He is the one that is on-site and will be there. If you screw it up by doing something besides what he told you to do then your A$$...
  3. Replies
    122
    Views
    9,563

    I'm with BT on all points including the original...

    I'm with BT on all points including the original call of the RV being the cause.
  4. Replies
    13
    Views
    3,202

    :cheers: yep lol

    :cheers: yep lol
  5. Replies
    13
    Views
    3,202

    Not sure what the design temps are. Engineers are...

    Not sure what the design temps are. Engineers are tight with their calcs. I tried to get the heat load out of them, they responded with " you don't need them".

    Our frost line is at 18" thats a...
  6. Replies
    13
    Views
    3,202

    Thanks Eric it does help. The pipe is at 4'...

    Thanks Eric it does help. The pipe is at 4' depth. They are concerned about the glycol/water at 32* freezing the ground and affecting the slab at that time. The point is really moot as we have...
  7. Replies
    13
    Views
    3,202

    HDPE pipe insulation

    We are looking at running our GLS & GLR under the building vs around the building. The engineer said that its ok as long as we insulate the pipe to keep the ground from freezing from low pipe temps....
  8. Replies
    29
    Views
    4,368

    Welcome pirate. Lots of good info here with good...

    Welcome pirate. Lots of good info here with good guys. I've seen the site grow from a 1 street town to a metropolis. lol I cant spell or type either and sometimes catch grief 4 it. just roll with it...
  9. I'm with Bob on all points also.

    I'm with Bob on all points also.
  10. IMO Sounds like the gas valve to me, as it is...

    IMO Sounds like the gas valve to me, as it is mechanical with an accent of pressure change( for lack of better explanation lol). Removing the cover eliminates the sound, their is a pressure...
  11. Replies
    5
    Views
    510

    A manual J load calc is what you want. The...

    A manual J load calc is what you want. The calculation takes the building structure and calculates your heat loss or heat gain. At the top of the page it says hvac calc in the blue banner. I believe...
  12. Replies
    10
    Views
    1,072

    :ditto: Another price check would be best.

    :ditto: Another price check would be best.
  13. Replies
    32
    Views
    4,439

    :LOL:

    :LOL:
  14. Replies
    10
    Views
    1,072

    If he knew you were going to replace the whole...

    If he knew you were going to replace the whole system when he did the furnace, then you guys should of replaced the coil also. If he has to tear the furnace back out again to replace the coil. Then...
  15. Replies
    8
    Views
    1,388

    That question is going to get answers accross the...

    That question is going to get answers accross the board.
    Currently not enough info to give you input.

    I like high efficency equipment matched indoor and outdoor.
    If your just changing the...
  16. Replies
    2
    Views
    1,796

    You had a tech out? And Move the das is all he...

    You had a tech out? And Move the das is all he suggested?

    Your going to have to get a tech out that knows what he's doing. Your system is running in heating mode if cold air is blowing out of the...
  17. Replies
    122
    Views
    9,563

    Tostaky go on line and google it, they will get...

    Tostaky go on line and google it, they will get you a ball park amount.

    I have replaced whole units vs a compressor before that was just out of warranty. For the same cost as a compressor change...
  18. Replies
    122
    Views
    9,563

    I don't think he's laughing at you but, He...

    I don't think he's laughing at you but, He obviously doesn't feel he made a mis-judgement enough to warrant fixing the situation.

    My advise is just have someone else repair the unit, pay for it...
  19. Replies
    7
    Views
    1,730

    If you wait til the C model comes out in 2 months...

    If you wait til the C model comes out in 2 months you'll get 3 extra zip-ties. Just kidding, I'm not sure when the C model comes out.
  20. Replies
    32
    Views
    4,439

    All the uv light issues I've seen are from bad...

    All the uv light issues I've seen are from bad installs.
  21. I'm a Lennox dealer and you most likely get your...

    I'm a Lennox dealer and you most likely get your Lennox parts cheaper than me. Closest warehouse is is 3 hours away, freight charges apply if I don't have it.
  22. Replies
    122
    Views
    9,563

    I agree 200%

    I agree 200%
  23. Replies
    122
    Views
    9,563

    Your enlish is god I have no problem with it. ...

    Your enlish is god I have no problem with it.

    I wonder how he is going to fix your warranty with Lennox?

    No I dont think a 18 months is normal for a compressor to fail. It should be warranteed...
  24. Replies
    122
    Views
    9,563

    You have an expensive repair thats agood reaon to...

    You have an expensive repair thats agood reaon to lie. In fact thats the #1 reason we get lied to.

    i bought my nephew an expensive bicycle to do tricks on in the dirt. Well hes out just trashing...
  25. Replies
    122
    Views
    9,563

    I don't understand the claim. Lennox is...

    I don't understand the claim.

    Lennox is going to stand by the contractor. Why should they give away parts when its not taken care of.
Results 1 to 25 of 470
Page 1 of 19 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event