Search:

Type: Posts; User: SkullMonkey

Page 1 of 17 1 2 3 4

Search: Search took 0.02 seconds.

  1. Without seeing the condition of that Evap coil...

    Without seeing the condition of that Evap coil you are dead in the water. It sounds like its plugged up, or
    you could have a restricted metering device. My guess is it's flooding back due to a...
  2. Repairman electrocuted on St. Augustine Beach gas station roof.

    http://www.clickorlando.com/news/repairman-electrocuted-on-st-augustine-beach-gas-station-roof/27001030

    A man was found dead after working on a cooling unit at a gas station in St. Augustine early...
  3. Replies
    3
    Views
    211

    Question for you appliance guys.

    What is a good brand for a refrigerator.
    We are looking into another side by side or a French door.
  4. Replies
    13
    Views
    669

    Raise your prices , then if you still have more...

    Raise your prices , then if you still have more work than you can handle hire another tech.
  5. Thread: Shaving

    by SkullMonkey
    Replies
    22
    Views
    826

    I shave in the shower with no mirror and touch up...

    I shave in the shower with no mirror and touch up afterwards too. I use shampoo instead of shaving cream in the shower.
  6. Replies
    5
    Views
    276

    STOL - Short Take Off and Landing

    STOL - Short Take Off and Landing
  7. Replies
    1
    Views
    239

    You will need a $10,000 bond, however if you take...

    You will need a $10,000 bond, however if you take an approved financial stability course (14 hours) the bond amount is cut in half to $5000.
  8. Replies
    19
    Views
    787

    Why don't you like the Testo's ?

    Why don't you like the Testo's ?
  9. Replies
    13
    Views
    713

    The low speed tap if it was a 3 spd motor is a...

    The low speed tap if it was a 3 spd motor is a 1/4 hp , they are assuming the rpm's will drop to around 825.
  10. Replies
    5
    Views
    309

    They sell a UV dye remover.

    They sell a UV dye remover.
  11. Replies
    18
    Views
    950

    The problem is when another tech goes there and...

    The problem is when another tech goes there and replaces your 1/2 hp with a 3/4 hp because he didn't have a 1/2 hp on the truck.
  12. Thread: Brazing

    by SkullMonkey
    Replies
    25
    Views
    1,268

    I have both rigs. Oxy - Acet for TXV type work. ...

    I have both rigs. Oxy - Acet for TXV type work. Air -Acet for lines sets and pulling coils.
  13. Apply at different shops. To some your dui's may...

    Apply at different shops. To some your dui's may be an issue to others not.
    Make sure you do not get another one!
  14. Replies
    23
    Views
    1,393

    Walterc that's a nice setup.

    Walterc that's a nice setup.
  15. If a customer orders a part I will gladly install...

    If a customer orders a part I will gladly install it and warranty my labor. If said part is defective or malfunctions I will gladly remove it so the customer can mail it back and fight for a...
  16. Replies
    23
    Views
    1,262

    I have seen a time delay cause the contactor to...

    I have seen a time delay cause the contactor to chatter.
  17. A multimeter , fluke or fieldpiece. Besides...

    A multimeter , fluke or fieldpiece. Besides basic hand tools the company will provide you with vacuum pumps and recovery machines etc.
  18. Check Preston's Guide.

    Check Preston's Guide.
  19. For 5 tons and under a 2 cfm pump is the way to...

    For 5 tons and under a 2 cfm pump is the way to go. Light weight and less expensive. 5 cfm or larger is more than you really need for resi.
  20. Replies
    48
    Views
    2,186

    Try to find a course at a state or county...

    Try to find a course at a state or county vocational school. Check with your local school board and community colleges, good courses can be found at a fraction of the cost private schools.
  21. Replies
    4
    Views
    563

    Is it still available?

    Is it still available?
  22. Sorry for the double post within a post.

    Sorry for the double post within a post.
  23. I know of quite a few guys around here who work...

    I know of quite a few guys around here who work like that. One in particular works for the
    Dept of Corrections (doing hvac) ,he drives his service truck to work . He does his service calls after...
  24. Replies
    58
    Views
    3,075

    How about this situation : Joe leaves company A...

    How about this situation : Joe leaves company A and goes to work at company B, Joe is well liked by many of the customers and some follow him to company B.

    The owner of company A says Joe is...
  25. Replies
    2
    Views
    385

    Never even heard of that brand.

    Never even heard of that brand.
Results 1 to 25 of 422
Page 1 of 17 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event