Search Results - HVAC-Talk: Heating, Air & Refrigeration Discussion

Search:

Type: Posts; User: FFG

Search: Search took 0.00 seconds.

  1. Replies
    28
    Views
    1,662

    If you decide to replace the burner assembly i...

    If you decide to replace the burner assembly i would go with a Beckett
  2. Thread: Ducane

    by FFG
    Replies
    12
    Views
    900

    Yes the company has been a supplier for many...

    Yes the company has been a supplier for many years and seem to be very helpful with the parts on units i have repaired for other companys. I will ask about parts available for some of the newer...
  3. Thread: Ducane

    by FFG
    Replies
    12
    Views
    900

    Ducane

    We are a Coleman dealer and have been asked if we might like to carry the Ducane line any input???
  4. Replies
    21
    Views
    1,053

    If you can get it into the garage why cant you...

    If you can get it into the garage why cant you then turn it to an outside wall?
  5. Replies
    10
    Views
    892

    stainless?

    check to see if the old roof jack has a stainless liner. the new high efficiency units use stainless liners to prevent corrosion to the stack. verry important
  6. Replies
    32
    Views
    1,637

    You have plenty of room for a filter,call your...

    You have plenty of room for a filter,call your oil company and have them install the filter and the required safety valve(firex valve) at the same time. Well at least they flared the copper!
  7. Replies
    22
    Views
    1,276

    Amen to that:)

    Amen to that:)
  8. Replies
    24
    Views
    1,079

    Reread the post are you using zone valves to...

    Reread the post are you using zone valves to control the pump(end switch) or is the limit control (aquastat)controlling the pump?
  9. Replies
    32
    Views
    1,637

    if you use a 1a filter housing you can get it...

    if you use a 1a filter housing you can get it inside the unit housing itself which i hate to do but sometimes we have no choice KEN
  10. Replies
    32
    Views
    1,637

    are the bodies of the shutoffs brass with a round...

    are the bodies of the shutoffs brass with a round knob on top???
  11. Replies
    10
    Views
    1,545

    Pump

    Just make sure he sizes the heat pack correctly for those cold nights, I dont know the heat extremes for your area but be sure that the cooling side is sufficient KEN
  12. Replies
    26
    Views
    7,750

    Pex

    Try aqua pex or water pex search
  13. Replies
    32
    Views
    1,637

    pump

    the black box thing is your oil pump you will notice on top of that there is a smaller copper line going to your blast tube assembly which connects to the nozzle, from what i can see from your...
  14. Replies
    24
    Views
    1,079

    boiler

    the boiler is reaching set temp and shutting off burner ok, the pump runs after the burner shuts off ok it will continue this until it drops to the low limit then the burner will bring it back to...
  15. Thread: Smartvalve

    by FFG
    Replies
    8
    Views
    1,696

    Smartvalve

    maybe i asked the wrong question from the start of this thread,and i just got my post privliges fixed i think! if you check the cross ref on the part it is correct, transformer is a 40va,and...
  16. Thread: Smartvalve

    by FFG
    Replies
    8
    Views
    1,696

    Smartvalve

    replaced sv9500m 2674 valve with Honeywell SV9501m 2528 on a heil unit and it blows the fuse for the 24 volt transformer. Plug in the old valve and its fine. No mods specified in the replacement...
Results 1 to 16 of 16
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event