Search:

Type: Posts; User: ammonia man

Search: Search took 0.01 seconds.

  1. Replies
    0
    Views
    562

    Want to buy Electrozone coils

    Hi I need to purchase some obsolete electrozone zone valve coils (don't need the valve itself) These are the types used with the RB-4 relay on Hydrotherm systems (and others) If you have any old...
  2. Replies
    26
    Views
    1,483

    You are right , I should have read the rules.I...

    You are right , I should have read the rules.I was not aware of the "no step by step " instructions. I just wanted to help this guy out. Randy
  3. Replies
    26
    Views
    1,483

    Air mechanical If you read his post he says he...

    Air mechanical If you read his post he says he checked the rating plate on the compressor. He was not including the condensor fan or anything else. You will also see that i advised him to get a tech...
  4. Replies
    1
    Views
    1,266

    Electrozone DC zone coils needed!!

    Hi I need to purchase some obsolete electrozone zone valve coils (don't need the valve itself) These are the types used with the RB-4 relay on Hydrotherm systems (and others) If you have any old...
  5. Replies
    26
    Views
    1,483

    Beenthere , his unit calls for a minimum of 25...

    Beenthere , his unit calls for a minimum of 25 amps ,he is only drawing 16 under load.He is not obtaining an acceptable T-D Split on hotter days. His split is only 11 degrees (read his previous...
  6. Replies
    26
    Views
    1,483

    If you have a 230/240 volt compressor you only...

    If you have a 230/240 volt compressor you only read the draw on one leg not both. 16 amps is lower than called for and it is likely that you are low on charge (or have a weak compressor)as that will...
  7. Replies
    26
    Views
    1,483

    amp draw

    A high amp draw at the condensor generally indicates one of a few things , a dirty condensor causing high head pressure , a weak compressor run capacitor , a condensor fan running too slowly (check...
  8. Replies
    26
    Views
    1,483

    By the way ,everyone is going to be shocked by...

    By the way ,everyone is going to be shocked by their bills because the power compnay can now pass along to you the cost increase in fuel that is used to generate your power. If they are using oil or...
  9. Replies
    26
    Views
    1,483

    Hi An 11 degree spead is too low.Look for about...

    Hi An 11 degree spead is too low.Look for about 18-20 spread across the evaporator. If you know how to check superheat,see what it is.Their is often a chart , on the outside unit that will tell you...
Results 1 to 9 of 9
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event