Type: Posts; User: bkirchner81
Search took 0.00 seconds.
thank you Mr. Bungalows. I will try that and get back to you with more questions! haha.
Say I have 4 VAV's heating a hallway. Can I create a math block or some type of point where I can adjust the temp setpoints of ALL FOUR VAV's with one point on the screen ?
Thank guys (Jogas I...
wow, very good information from all of you guys.
thank you very much, this has been very helpful to us. :D
HVAC-Talk is the schnizz....
hey I wanna thank you guys for helping me out. Mucho Appreciado.
We are still looking into several options, and we'll take any input from you guys.
My company is looking to install controls in one of our maintained buildings.
Can anyone provide me with some pros or cons of the invensys TAC Micronet BACnet system?
We use Staefa MS1800 in...
""• Digital—15 characters for the units value of the current state (active or inactive).
Note: If the “Hide Status” parameter on the System Manager User Setup screen is
selected, this option hides...
when I install MS1800 on a new machine- the graphical display of all points in 'automatic' have an "AU" in front of the numbers. Everything in a manual state has "MN" in front, ...
It was not completely dead, no. The transformer itself? I believe it was fine also.
It appears that all communication ports were lost- LAN, Serial, (the Ethernet port on this board was...
easy friends, im still here. Just a little busy.
It was our Master "A" board. Appearently what caused the initial power outage was a lightning strike to the building. This was the...
Could be the Node is trying to dial out or connect to a printer on the port you're on.
At this point I have deleted the database- our modem was connected to host A but that should be irrelevant...
Are you sure you have the correct settings and port for a dirrect connection?
Could be the Node is trying to dial out or connect to a printer on the port you're on. Check the dip switch...
I work in a LARGE building with about 20 NCRS panels which are used to communicate between DDC boards and my controls computers.
A power outage occurred Monday night and now I...