Search:

Type: Posts; User: huskerdu

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    If you look it could not be simpler all...

    If you look it could not be simpler all thermostat wires run to seperate cube relays and clearly marked r,y,c, ....... you can check low voltage power to any unit without opening it up. If only...
  2. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    no way to split the return it is all under...

    no way to split the return it is all under concrete in a large shared return in a theatre
  3. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    Stopped by yesterday for a normal fall check up,...

    Stopped by yesterday for a normal fall check up, nobody touches thus equipment but me and i havn't even changed an ignitor. cleaned the outside coils on the heatpumps spring and fall. never added...
  4. Replies
    7
    Views
    860

    Love the Amprobe. Takes sime practice but when...

    Love the Amprobe. Takes sime practice but when you get it, works great!!
  5. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    Just checking back in another note went up to...

    Just checking back in another note went up to them yesterday had a bad contactor on one of the HP units still cranking out cold and heat not even an ignitor out just like the energiser bunny keeps...
  6. Replies
    44
    Views
    3,835

    Have been checking hgb in diff books but am...

    Have been checking hgb in diff books but am heading now to the sporlan site
  7. Replies
    44
    Views
    3,835

    With the old system it was set up with soleniod...

    With the old system it was set up with soleniod valves and thermostats, on each case. when one was running, it just ran, I have been concerned with it for quite a while, when it was running under a...
  8. Replies
    44
    Views
    3,835

    The head pressure is not a problem am running a...

    The head pressure is not a problem am running a water coil so I can set the Head at whatever I want and with fresh water it will stay with a head press water valve
  9. Replies
    44
    Views
    3,835

    I see your point, thanks for all your time and...

    I see your point, thanks for all your time and info, by the way, can you direct me to a web site that shows a chart for H.P. to BTU. conversions been looking but copelands website is hard to follow...
  10. Replies
    44
    Views
    3,835

    Re: Getting back to controls......

    Could I not do the same thing with a manual epr set to the pressure/temp differential to control the temp of the evap.? and just leave the compressor running all the time only using the solenoids to...
  11. Replies
    44
    Views
    3,835

    From what the store owner tells me the Tyler guy...

    From what the store owner tells me the Tyler guy walked in and sold the units then told him the compressor was just fine. then walked out not to be seen again. you have to undersand the nearest town...
  12. Replies
    44
    Views
    3,835

    So what I am reading here is my compressor...

    So what I am reading here is my compressor ACA-031A-TAC-800 will not have enough btus to run the cases? and my copeland rep doesn't know his stuff.the three cases are going to run,as freeze said...
  13. Replies
    44
    Views
    3,835

    I told him about all three and gave him the...

    I told him about all three and gave him the numbers from the tyler site and the size of the Friedrich cooler
  14. Replies
    44
    Views
    3,835

    the N3M tyler is 12 ft and is for fresh cut meat...

    the N3M tyler is 12 ft and is for fresh cut meat the N6D is an 8 ft for deli. and cheese the friedrich is also a deli case so i am guessing a 34 degree discharge temp it is also an 8' case with three...
  15. Replies
    44
    Views
    3,835

    the two tylers are N6DHPM, AND N3MGHP.What do...

    the two tylers are N6DHPM, AND N3MGHP.What do you think my risks are to just putting suction line regulators on each of the units and letting them run, especially since they pump down on the off...
  16. Replies
    44
    Views
    3,835

    can you elaborate on the suction cutoff...

    can you elaborate on the suction cutoff unloading? are you speaking of a single regulator before the compressor that is shaped like an L and has an adjustable hex screw under a cover on the front??...
  17. Thread: Ponderisims

    by huskerdu
    Replies
    78
    Views
    15,977

    why do people say they found it in the last place...

    why do people say they found it in the last place they looked? of coursi its the last place, if they find it why keep looking
  18. Replies
    44
    Views
    3,835

    have a local grocery store replacing a 20 ft meat...

    have a local grocery store replacing a 20 ft meat case with a set of two upright display cases. on a single compressor, o by the way have a lunch meat case also on this compressor, so will have a...
  19. Replies
    36
    Views
    7,764

    WOW What a Thread!! Its a good thing this is not...

    WOW What a Thread!! Its a good thing this is not a football site or a ford chevy site it could come to fisticuffs!!!
    LOL LOL!! Seems to me the install has as much to do with the longevity of a unit...
  20. Replies
    12
    Views
    3,515

    Yes have been doing this with the ballast valve...

    Yes have been doing this with the ballast valve but have not tried changing the oil half way through. this may be an answer thanks. will try.
    I do change it after every vacuum that I do.

    keep it...
  21. Replies
    5
    Views
    805

    Getting some calls for work on these. never a...

    Getting some calls for work on these. never a high side valve only low. How can you charge these units efficiently without a high side line tap? most of them are old 12 units switched to 401a. most...
  22. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    comming up on year two. not even a hiccup. fired...

    comming up on year two. not even a hiccup. fired them up and never looked back. Been installing goodman from day one and before, many janitrol units before that.have a great success ratio. doesn't...
  23. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    I have found T's on the exhaust to be invaluable,...

    I have found T's on the exhaust to be invaluable, on cold crisp nights it lets some of the moisture to escape straight up instead of down or condensing on the end of an elbow and freezing. JMO
    ...
  24. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    http://img85.imageshack.us/img85/9610/p1010009sy3....

    http://img85.imageshack.us/img85/9610/p1010009sy3.jpg

    solid state relays for each connection from the thermostat

    I am amazed each time the furnaces fire it is like a symphony identical timing...
  25. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    http://img46.imageshack.us/img46/7748/p1010010xh8....

    http://img46.imageshack.us/img46/7748/p1010010xh8.jpg

    back to back gms9090 variable speed units
  26. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    http://img157.imageshack.us/img157/9623/p7250001tm...

    http://img157.imageshack.us/img157/9623/p7250001tm7.jpg

    Another angle of the outdoor units
    There is more room between them than it looks you can
    walk between them
    That box on the wall is an...
  27. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    http://img67.imageshack.us/img67/533/p7250002fp6.j...

    http://img67.imageshack.us/img67/533/p7250002fp6.jpg

    More Condensers/Heatpumps
    other side
  28. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    http://img123.imageshack.us/img123/7761/p7250003ky...

    http://img123.imageshack.us/img123/7761/p7250003ky3.jpg

    ok lets try this
    condensers/heatpumps
  29. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    ]

    ]
  30. Thread: QUAD??

    by huskerdu
    Replies
    54
    Views
    12,385

    Here is my Idea of 16 tons of cooling and almost...

    Here is my Idea of 16 tons of cooling and almost 400,000 btu of heating . All heat pumps and 93% furnaces
    cplt48 and gms9090 variable speed furnaces. My supplier said you could not twin the...
  31. Replies
    12
    Views
    3,515

    I have been using the same jb 3cfm pump for 20...

    I have been using the same jb 3cfm pump for 20 years been a good unit on new installs and light pumpdowns after fixing leaks in linesets, but when I have had burnouts or trying to vacuum condensers...
  32. I use MP39 and get along great with small...

    I use MP39 and get along great with small hermetics and small reach i n coolers 408 for low temp here.

    [Edited by huskerdu on 07-16-2006 at 01:19 PM]
  33. Replies
    9
    Views
    1,058

    I think you said it yourself but you never said...

    I think you said it yourself but you never said what the original control did, operates the compressor? the fan control will never work on a head pressure control properly. A fan control cuts in on...
  34. Thread: "The Hook"

    by huskerdu
    Replies
    3
    Views
    1,122

    Had a salesman come in the other day and sell me...

    Had a salesman come in the other day and sell me these torch tips called "the hook" said they would heat the pipe evenly around the pipe. Tried the large one but keeps blowing the flame out on a 7/8...
  35. Thread: New Coil Gun

    by huskerdu
    Replies
    9
    Views
    1,602

    Fantastic machine been using them for years, the...

    Fantastic machine been using them for years, the old ones had a brass adjustment that always got stuck!! The new ones are much better with the plastic wheel to adjust the mixture, most of the time I...
  36. Replies
    1
    Views
    565

    I have a mom and pop bar that has a cornielius...

    I have a mom and pop bar that has a cornielius Ice machine When I got there it would not drop the Ice! OK plate dirty,but as I check it out and start cleaning the goop from the manifold I notice that...
  37. Replies
    0
    Views
    1,000

    A man and woman see a minister about getting...

    A man and woman see a minister about getting married, the minister says "I will marry you if you can abstain from any sexual relations for 6 weeks." The man and woman agree and return to see the...
Results 1 to 37 of 100
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event