Search:

that is a very nice job. i commend you on paying attention to detail. i have experienced installers that don't pay that much attention to detail. are you looking for a new job??

the reason manufacturers recomend brazing is because most techs do not put the time to do it right, if you clean the fittings good and make sure of a good joint it will last longer than the unit....

how did you get the pics on? i tried to post and my pics where too big. the site told me to down size but i don't know how.

i would like to hear what they say? a sting would be nice but might not do much, people don't pay attention. a company around here was investigated, and fined twice for ripping off customers in last...

payson, congrats on new job. i'm sure everything will work out well for you. i'm glad to see there is someone out there who appreciates your pride in what you do and seeked your services.

that advertising just might be gay enough to actually work.

correct me if i'm wrong but carrier is offered through sears. and i think carrier makes kenmore. be careful with sears they hire sub contractors, make sure they are reputable

get someone to do a man j room by room, sounds like you need more supply and returns to the den, just increasing size of ah will not deliver anymore air to or from the den. you may need duct...

[QUOTE]Originally posted by PaysonHVAC
[B]

I haven't seen it get that bad aournd here yet.



But is it getting DEEP around here.
This morning they were looking through our invoices and I...

make sure the installer set the dip switches according to equipment size and specifications.

the steelers are the only team i know that has had the head of officials call several different times over last 5 years to offer apologies for wrong calls. one that comes to mind bettis's coin flip...

[QUOTE]Originally posted by RoBoTeq


You want to dispute what I stated with something more then a contradiction?

While TXVs control superheat which allows systems to operate more evenly...

you tell him DR. i've always said " the man who calls another man dumb is generally dumb himself"

it looks like a dryer vent?

i do not pay on commission for just that reason, i don't want my techs selling something that doesn't need replaced. i agree with paying a good hourly wage and do a good thorough and honest job. i...

what size are your supply and return ducts? how many supply vents and return vents do you have throughout house?

you can single pipe any of the 90+ furnaces, but it changes heat exchanger warranty to 20 year instead of lifetime

sure you can terminate with one penetration by using a concentric kit

no rubber grommet or romex connector on low voltage either.

do you show your boss these pics? i've seen a few of your threads and it seems like alot are from your company. what does your boss say? think? or is he just as much a hack? i hope your the highest...

the federal requirement is no cooling units may be manufactured after jan 26 2006. but anything out standing can be installed. including 10 seer
and you are correct about txv. except for goodman,...

you don't need a seperate air handler, just the VS furnace evap coil, and instead of just air conditioner use a heat pump

you should be fine as long as you use the piston that comes with the condenser. you will still lose the 13 seer efficiency but will work ok.

i agree with bart, use a carrier or bryant, with infinity or evolution control. and i also recommend using the 2 speed (or 2 stage) condenser too. works great with 2 stage furnace. you could get...

i would use the 2 stage variable speed furnace and would also use a xl19i, or xl16i. these are two speed air conditioners and remove up to 50% more humidity than single speed units. i live in PA and...